SYM8951U sees ch0 but not sa0

[Dan Langille]

On 2014-03-28 05:31 PM, Matthias Andree wrote:
> Am 28.03.2014 21:59, schrieb Dan Langille:
>>> - Does camcontrol reportluns help any?
>> 
>> $ sudo camcontrol reportluns 7:3:0
>> 1 LUN found
>> 0
> 
> Sorry for distracting you on the LUNs.
> 
> The manual for HP StorageWorks MSL5000 and MSL6000 Series Tape 
> Libraries
> clearly states the drives are individual SCSI targets.
> 
> 
> <http://h10032.www1.hp.com/ctg/Manual/c01125957.pdf> found as
> 3rd from the BOTTOM of
> <http://h10025.www1.hp.com/ewfrf/wc/manualCategory?cc=us&lc=en&dlc=en&tmp_geoLoc=true&document=&product=329885>
> 
> 
> Apparently (see page 199 in the PDF) there is no internal SCSI wiring,
> you need to add all SCSI wires by yourself - i. e. drives must be
> daisy-chained to the library controller.
> 
> Can you see the drive if you move the SCSI cable and terminator from
> library to drive, or if you daisy-chain things?

I did try swapping the cable and the terminator between the two 
connectors on the rear of the library.  I ran 'camcontrol rescan all' 
and 'camcontrol devlist' after each swap.  Never saw the drive.

By daisy-chain things, there are only two connectors on the rear, so I'm 
not sure what else I could try, other than the above.

-- 
Dan Langille - http://langille.org/