kern/146287: [ciss] ciss(4) cannot see more than one SmartArray controller

[Sean Bruno]

On Wed, 2010-05-05 at 18:47 -0700, Ulf Zimmermann wrote:
> > > Ok, found a machine and hooked it up. DL380 g4, has single port Qlogic Fibre
> > > channel HBA in slot 1 and 2 right now. What version should I install? 8-REL?
> > > Current?
> > > 
> > 
> > Current if you please.
> > 
> > sean
> 
> Turns out the iLO on the system I first grabbed is busted, so I grabbed
> another one. DL380 g4 with SmartArray P600 in slot 2 (middle) and a LSI
> 1030 based U320 controller in slot 3 (top). Both show up on -CURRENT:
> 
> ciss0: <HP Smart Array 6i> port 0x4000-0x40ff mem 0xfdef0000-0xfdef1fff,0xfde80000-0xfdebffff irq 51 at device 3.0 on pci4
> ciss0: PERFORMANT Transport
> ciss0: got 0 MSI messages]
> ciss0: [ITHREAD]
> ciss1: <HP Smart Array P600> port 0x5400-0x54ff mem 0xfdfb0000-0xfdfb1fff,0xfdf40000-0xfdf7ffff irq 78 at device 2.0 on pci6
> ciss1: PERFORMANT Transport
> ciss1: got 0 MSI messages]
> ciss1: [ITHREAD]
> da0 at ciss0 bus 0 scbus0 target 0 lun 0
> mpt0: <LSILogic 1030 Ultra4 Adapter> port 0x5000-0x50ff mem 0xfdfe0000-0xfdffffff,0xfdfc0000-0xfdfdffff irq 74 at device 1.0 on pci6
> 
> 
> 

So putting a card into the slot that failed on the previous machine
works now?  Madness.

Can you check that both machines are running the same BIOS rev and then
dump the dmesg+pciconf of the "new" machine here as well?

Sean