D-Link DGE-560SX (Marvell 88E8061-based) doesn't see link

[Eugene Perevyazko]

On Fri, Sep 04, 2009 at 02:22:23PM -0700, Pyun YongHyeon wrote:
> 
> Would you back out previous changes and apply the patch at the
> following URL?
> http://people.freebsd.org/~yongari/msk/msk.DGE560.diff2
> 
> Note, I have no more access to msk(4) hardwares so it wasn't tested
> at all except compilation.
>

Still no success.
 
mskc0: <D-Link 560SX Gigabit Ethernet> port 0xd800-0xd8ff mem 0xfeafc000-0xfeafffff irq 16 at device 0.0 on pci1
msk0: <Marvell Technology Group Ltd. Yukon XL Id 0xb3 Rev 0x03> on mskc0
msk0: Ethernet address: 00:21:91:52:4f:09
miibus0: <MII bus> on msk0
e1000phy0: <Marvell 88E1112 Gigabit PHY> PHY 0 on miibus0
e1000phy0:  1000baseSX, 1000baseSX-FDX, auto
mskc0: [FILTER]

ifconfig -m msk0
msk0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
        options=11a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING,TSO4>
        capabilities=11a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING,TSO4>
        ether 00:21:91:52:4f:09
        inet 10.2.3.1 netmask 0xffffff00 broadcast 10.2.3.255
        media: Ethernet autoselect (autoselect <full-duplex>)
        status: active
        supported media:
                media autoselect
                media 1000baseSX mediaopt full-duplex
                media 1000baseSX
                media none

Switch shows no link on the port.

# ifconfig msk0 media 1000baseSX mediaopt full-duplex
# ifconfig msk0
msk0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
        options=11a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING,TSO4>
        ether 00:21:91:52:4f:09
        inet 10.2.3.1 netmask 0xffffff00 broadcast 10.2.3.255
        media: Ethernet 1000baseSX <full-duplex> (autoselect <full-duplex>)
        status: active

Switch shows no link again.

All dev.msk.0.stats counters are zero even after trying broadcast ping.

I can arrange you root access to the host with this NIC if you have time/wish.

-- 
Eugene Perevyazko