400/800 card

[Hidetoshi Shimokawa]

try 'fwcontrol -p'.


On Wed, Jun 11, 2008 at 10:07 PM, Sean Bruno <sbruno at miralink.com> wrote:
> Hidetoshi Shimokawa wrote:
>>
>> On Wed, Jun 11, 2008 at 10:56 AM, Sean Bruno <sbruno at miralink.com> wrote:
>>
>>>
>>> I have a 400/800 card installed in my RELENG_7 box that has one 800
>>> connector and two 400 connectors on it.  Looking over the system, I
>>> wonder
>>> if the card is working correctly when I attach a S400 device to it:
>>>
>>> [sean at home-test ~]$ sudo fwcontrol -t
>>> crc_len: 3 generation:1 node_count:1 sid_count:1
>>> id link gap_cnt speed delay cIRM power port0 port1 port2 ini more
>>> 00    1      63  S800     0    1   -1W     -     -     -   1    0
>>>
>>
>> The phy layer doesn't seem to recognize the S400 device.
>> It seem to be a hardware problem.
>> Are your cable and connector o.k.?
>> Did a bus reset occur when you attached the device?
>>
>
> The output of fwcontrol was generated with no attached device.  I thought I
> would see
> a report of both the S400 and S800 capable ports in the output.
>
> Sean
>
>



-- 
/\ Hidetoshi Shimokawa
\/ simokawa at FreeBSD.ORG