kern/123053

[Pyun YongHyeon]

On Thu, Apr 24, 2008 at 05:54:13PM -0500, Eric F Crist wrote:
 > Andrey,
 > 
 > I've applied the patch to a 7.0-RELEASE-p1 source tree and rebooted my  
 > system.  The card comes UP ok, but shows the following when connected  
 > to a 100BaseT/ Full Duplex switch port:
 > 

By chance, are you referring to kern/123053?

 > re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
 > 	options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM>
 > 	ether 00:1f:c6:52:7b:80
 > 	media: Ethernet autoselect (10baseT/UTP <half-duplex>)
 > 	status: active
 > 
 > Once I've assigned an IP to the interface, however, it comes up  
 > correctly and seems to function just fine.  Is there any load testing  

I think, that's normal.

 > I should perform for you folks?
 > 

Try one of network benchmarks in ports/benchmarks if you want.

 > re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu  
 > 1500
 > 	options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM>
 > 	ether 00:1f:c6:52:7b:80
 > 	inet 10.0.0.38 netmask 0xffff0000 broadcast 10.0.255.255
 > 	media: Ethernet autoselect (100baseTX <full-duplex>)
 > 	status: active
 > 
 > 
 > -----
 > Eric F Crist
 > Secure Computing Networks
-- 
Regards,
Pyun YongHyeon