kern/123053

[Eric F Crist]

Andrey,

I've applied the patch to a 7.0-RELEASE-p1 source tree and rebooted my  
system.  The card comes UP ok, but shows the following when connected  
to a 100BaseT/ Full Duplex switch port:

re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
	options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM>
	ether 00:1f:c6:52:7b:80
	media: Ethernet autoselect (10baseT/UTP <half-duplex>)
	status: active

Once I've assigned an IP to the interface, however, it comes up  
correctly and seems to function just fine.  Is there any load testing  
I should perform for you folks?

re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu  
1500
	options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM>
	ether 00:1f:c6:52:7b:80
	inet 10.0.0.38 netmask 0xffff0000 broadcast 10.0.255.255
	media: Ethernet autoselect (100baseTX <full-duplex>)
	status: active


-----
Eric F Crist
Secure Computing Networks