mini itx from via - acpi issues on 7.1R

[Nate Lawson]

Nenhum_de_Nos wrote:
> I sent this friday to stable@, but nothing as far. I'm trying this one
> now, hope better luck :)
> 
> matheus
> 
> hail,
> 
> I'm running 7.1R (tried 8.0-CURRENT also) on a via mini itx (dmesg bellow)
> and if I load acpi module, I have no lan. it appears, I can set IP, even
> the led would blink when I ping. but no signal of bits on the other pc
> whatsoever. tcpdump sees nothing in both endpoints. if acpi is not loaded,
> vr0 works as it should.
> 
> i really think acpi would help this box, on power purposes, so here I am
> asking.
> 
> thanks,
> 
> matheus
> 
> ps: should I mail acpi@ with, or instead ?

> pci0: <bridge> at device 17.4 (no driver attached)
> vr0: <VIA VT6102 Rhine II 10/100BaseTX> port 0xe600-0xe6ff mem
> 0xe8130000-0xe81300ff irq 15 at device 18.0 on pci0
> vr0: Quirks: 0x0
> vr0: Revision: 0x51
> miibus0: <MII bus> on vr0
> ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
> ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
> vr0: Ethernet address: 00:11:85:e3:2a:17
> vr0: [ITHREAD]
> 
> vr0 at pci0:0:18:0:	class=0x020000 card=0x01021106 chip=0x30651106 rev=0x51
> hdr=0x00
>     vendor     = 'VIA Technologies Inc'
>     device     = 'VT6102 Rhine II PCI Fast Ethernet Controller||Used by
> GERICOM in laptop Webengine Advanced'
>     class      = network
>     subclass   = ethernet

Maybe it's a PCI irq routing problem.

-- 
Nate