Re: Requiring SSE2 by default for i386

Sounds good.

On Mon, Nov 11, 2024 at 1:30 PM Nuno Teixeira <eduardo@freebsd.org> wrote:
>
> Ah, sure.
>
> I will add OPTIONS_DEFAULT=SSE2 and check if it will be problems for amd64 and aarch64.
> If everything ok then use this option since upstream default is SSE2 on by default.
>
> Sorry as I misread past email.
>
> Alan Somers <asomers@freebsd.org> escreveu (segunda, 11/11/2024 à(s) 16:25):
>>
>> I don't know what that "QMAKE_ON" part means.  But when I do "make
>> config", it shows the SSE2 option disabled by default.
>>
>> On Mon, Nov 11, 2024 at 5:20 AM Nuno Teixeira <eduardo@freebsd.org> wrote:
>> >
>> > (...)
>> >
>> > Just took a look at port Makefile and it's alleady set:
>> >
>> > OPTIONS_DEFINE= SSE2
>> > SSE2_DESC=      Enable SSE2 optimization
>> > SSE2_QMAKE_ON=  CONFIG+=sse2
>> > SSE2_QMAKE_OFF= CONFIG+=no-sse2
>> >
>> > This port does not have rust code.
>> >
>> > Alan Somers <asomers@freebsd.org> escreveu (domingo, 10/11/2024 à(s) 15:51):
>> >>
>> >> On Sun, Nov 10, 2024 at 7:00 AM Nuno Teixeira <eduardo@freebsd.org> wrote:
>> >> >
>> >> > Hello,
>> >> >
>> >> >> graphics/fraqtive
>> >> >
>> >> >
>> >> > https://github.com/mimecorg/fraqtive/blob/02914797f47d26c4098f4a3a945716b13998a8cc/INSTALL#L43
>> >> > Upstream says SSE2 is enabled by default.
>> >> >
>> >> > What should we do here?
>> >>
>> >> Just set OPTIONS_DEFAULT_i386=SSE2 or OPTIONS_DEFAULT=SSE2 in the port Makefile.
>> >
>> >
>> >
>> > --
>> > Nuno Teixeira
>> > FreeBSD UNIX:  <eduardo@FreeBSD.org>   Web:  https://FreeBSD.org
>
>
>
> --
> Nuno Teixeira
> FreeBSD UNIX:  <eduardo@FreeBSD.org>   Web:  https://FreeBSD.org