Re: ALPHA1 on Raspberry Pi 3B+ [added: and RPi4B]
- Reply: titus : "Re: ALPHA1 on Raspberry Pi 3B+ [added: and RPi4B]"
- In reply to: Emmanuel Vadot : "Re: ALPHA1 on Raspberry Pi 3B+ [added: and RPi4B]"
- Go to: [ bottom of page ] [ top of archives ] [ this month ]
Date: Mon, 14 Aug 2023 17:44:03 UTC
On 14 Aug 2023, at 11:19, Emmanuel Vadot wrote: > On Mon, 14 Aug 2023 10:55:39 -0500 > Mike Karels <mike@karels.net> wrote: > >> On 14 Aug 2023, at 10:44, titus wrote: >> >>> + if (OF_hasprop(ofw_bus_get_node(dev), "clock-frequency") == 0) { >>> + device_printf(dev, "clock-fixed have no clock-frequency\n"); >>> + return (ENXIO); >>> + } >>> this runs before compat_data is checked so will print it for any device clock or not > > Meh, that's why I should do code at 7am :) > >> Good point! Shuffling a bit to check both, I see 58 occurrences >> of the message. That's better than the 50+ 3-line sequences before. >> >> Mike > > Is that more or less than the previous message ? If it's the same > there is no point to commit this. It's the same number of occurrences, but before there were 3 lines per occurrence. Now it's 1, and it's more clear what it means. I'd say it's worth it. Mike >>>> On Aug 14, 2023, at 6:07 PM, Emmanuel Vadot <manu@bidouilliste.com> wrote: >>>> >>>> On Mon, 14 Aug 2023 09:51:27 -0500 >>>> Mike Karels <mike@karels.net> wrote: >>>> >>>>> On 14 Aug 2023, at 0:30, Emmanuel Vadot wrote: >>>>> >>>>>> On Mon, 14 Aug 2023 07:03:19 +0200 >>>>>> Emmanuel Vadot <manu@bidouilliste.com> wrote: >>>>>> >>>>>>> On Sun, 13 Aug 2023 12:35:31 -0500 >>>>>>> Mike Karels <mike@karels.net> wrote: >>>>>>> >>>>>>>> On 13 Aug 2023, at 12:19, Emmanuel Vadot wrote: >>>>>>>> >>>>>>>>> On Sun, 13 Aug 2023 11:25:25 -0500 >>>>>>>>> Mike Karels <mike@karels.net> wrote: >>>>>>>>> >>>>>>>>>> On 13 Aug 2023, at 11:10, Mark Millard wrote: >>>>>>>>>> >>>>>>>>>>> On Aug 13, 2023, at 08:17, Warner Losh <imp@bsdimp.com> wrote: >>>>>>>>>>> >>>>>>>>>>>> Manu just updated Linux DTS in the tree. Maybe see if you revert that if the problem persists. >>>>>>>>>>> >>>>>>>>>>> git: 69f8cc60aa1e - main - ofw_firmware: Only match if there is no compatible >>>>>>>>>>> >>>>>>>>>>> is the fix that Manu has committed: >>>>>>>>>>> >>>>>>>>>>> QUOTE >>>>>>>>>>> ofw_firmware: Only match if there is no compatible >>>>>>>>>>> >>>>>>>>>>> If there is a compatible string it likely means that the firmware needs >>>>>>>>>>> a dedicated driver (like on RPI*). >>>>>>>>>>> >>>>>>>>>>> PR: 273087 >>>>>>>>>>> Tested-by: Mark Millard <marklmi26-fbsd@yahoo.com> >>>>>>>>>>> Sponsored by: Beckhoff Automation GmbH & Co. KG >>>>>>>>>>> Fixes: fdfd3a90b6ce ("ofw: Add a ofw_firmware driver") >>>>>>>>>>> END QUOTE >>>>>>>>>> >>>>>>>>>> Just for completeness: that change fixes the bcm2835_cpufreq0/powerd >>>>>>>>>> problem and the gpioled0 problem, but not the clk_fixed2 problem >>>>>>>>>> (clk_fixed4 on rpi4). Installing an msdos boot partition from the >>>>>>>>>> 3 Aug image makes that problem disappear. >>>>>>>>>> >>>>>>>>>> Mike >>>>>>>>> >>>>>>>>> There is two fixed-clock in the DTB without clock-frequency property >>>>>>>>> and with a status set to "disabled", this isn't conforming to the >>>>>>>>> bindings >>>>>>>>> (https://cgit.freebsd.org/src/tree/sys/contrib/device-tree/Bindings/clock/fixed-clock.yaml) >>>>>>>>> so we complain on this, this is normal. >>>>>>>> >>>>>>>> Would it be possible to detect the disabled status to prevent the errors >>>>>>>> (I'm guessing not) or to suppress the repeats? 150 lines of errors seems >>>>>>>> like a lot for an out-of-spec DTB entry, and makes it hard to ignore. >>>>>>>> >>>>>>>> Mike >>>>>>> >>>>>>> Detecting the disabled status makes no sense, a fixed clock cannot be >>>>>>> disable, it's always present and running. >>>>>>> But I think that if we check that clock-frenquency isn't present in >>>>>>> the probe function, print a message and bail we will not attempt to >>>>>>> attach the driver at each pass. >>>>>>> That's the only clean solution that I can see without making dirty >>>>>>> hacks for some non-conforming DTB. >>>>>> >>>>>> Something like this : >>>>>> https://people.freebsd.org/~manu/0001-clk-fixed-Bail-early-if-there-is-no-clock-frequency-.patch >>>>>> >>>>>> Please let me know if that works. >>>>> >>>>> Not exactly. This results in: >>>>> >>>>> clk_fixed4: clock-fixed have no clock-frequency >>>>> >>>>> but this appears 1562 times. btw, "have" should be "has". >>>> >>>> Then I don't know how to fix this properly. >>>> >>>>> I hadn't noticed them before, but there are a lock order reversal >>>>> and a malloc while holding a non-sleepable lock, associated with >>>>> the gpio fix: >>>> >>>> Are you sure that they are new ? >>>> >>>>> gpioled0: <GPIO LEDs> on ofwbus0 >>>>> lock order reversal: (sleepable after non-sleepable) >>>>> 1st 0xffff000000d0f6f8 LED mtx (LED mtx, sleep mutex) @ /usr/src/sys/dev/led/led.c:298 >>>>> 2nd 0xffffa00001857c10 Raspberry Pi firmware gpio (Raspberry Pi firmware gpio, sx) @ /usr/src/sys/arm/broadcom/bcm2835/raspberrypi_gpio.c:252 >>>>> lock order LED mtx -> Raspberry Pi firmware gpio attempted at: >>>>> #0 0xffff0000004d3984 at witness_checkorder+0xa98 >>>>> #1 0xffff00000046ecb4 at _sx_xlock+0x7c >>>>> #2 0xffff0000008b1700 at rpi_fw_gpio_pin_set+0xe0 >>>>> #3 0xffff0000001c7400 at led_create_state+0x158 >>>>> #4 0xffff0000001910d4 at gpioled_attach+0x290 >>>>> #5 0xffff00000049efa4 at device_attach+0x3f8 >>>>> #6 0xffff00000049eb14 at device_probe_and_attach+0x7c >>>>> #7 0xffff0000004a0e54 at bus_generic_new_pass+0xfc >>>>> #8 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #9 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #10 0xffff00000049bd30 at bus_set_pass+0x4c >>>>> #11 0xffff0000003ea3bc at mi_startup+0x1fc >>>>> #12 0xffff0000000008ac at virtdone+0x70 >>>>> uma_zalloc_debug: zone "malloc-64" with the following non-sleepable locks held: >>>>> exclusive sleep mutex LED mtx (LED mtx) r = 0 (0xffff000000d0f6f8) locked @ /usr/src/sys/dev/led/led.c:298 >>>>> stack backtrace: >>>>> #0 0xffff0000004d3dc8 at witness_debugger+0x5c >>>>> #1 0xffff0000004d4fcc at witness_warn+0x400 >>>>> #2 0xffff0000007830a0 at uma_zalloc_debug+0x30 >>>>> #3 0xffff000000782c20 at uma_zalloc_arg+0x2c >>>>> #4 0xffff000000437abc at malloc+0x8c >>>>> #5 0xffff0000008a69b4 at bcm2835_firmware_property+0x44 >>>>> #6 0xffff0000008b1718 at rpi_fw_gpio_pin_set+0xf8 >>>>> #7 0xffff0000001c7400 at led_create_state+0x158 >>>>> #8 0xffff0000001910d4 at gpioled_attach+0x290 >>>>> #9 0xffff00000049efa4 at device_attach+0x3f8 >>>>> #10 0xffff00000049eb14 at device_probe_and_attach+0x7c >>>>> #11 0xffff0000004a0e54 at bus_generic_new_pass+0xfc >>>>> #12 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #13 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #14 0xffff00000049bd30 at bus_set_pass+0x4c >>>>> #15 0xffff0000003ea3bc at mi_startup+0x1fc >>>>> #16 0xffff0000000008ac at virtdone+0x70 >>>>> uma_zalloc_debug: zone "malloc-16" with the following non-sleepable locks held: >>>>> exclusive sleep mutex LED mtx (LED mtx) r = 0 (0xffff000000d0f6f8) locked @ /usr/src/sys/dev/led/led.c:298 >>>>> stack backtrace: >>>>> #0 0xffff0000004d3dc8 at witness_debugger+0x5c >>>>> #1 0xffff0000004d4fcc at witness_warn+0x400 >>>>> #2 0xffff0000007830a0 at uma_zalloc_debug+0x30 >>>>> #3 0xffff000000782c20 at uma_zalloc_arg+0x2c >>>>> #4 0xffff000000437abc at malloc+0x8c >>>>> #5 0xffff0000007ce15c at bounce_bus_dmamem_alloc+0x50 >>>>> #6 0xffff0000008a9404 at bcm2835_mbox_property+0xdc >>>>> #7 0xffff0000008a69e8 at bcm2835_firmware_property+0x78 >>>>> #8 0xffff0000008b1718 at rpi_fw_gpio_pin_set+0xf8 >>>>> #9 0xffff0000001c7400 at led_create_state+0x158 >>>>> #10 0xffff0000001910d4 at gpioled_attach+0x290 >>>>> #11 0xffff00000049efa4 at device_attach+0x3f8 >>>>> #12 0xffff00000049eb14 at device_probe_and_attach+0x7c >>>>> #13 0xffff0000004a0e54 at bus_generic_new_pass+0xfc >>>>> #14 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #15 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #16 0xffff00000049bd30 at bus_set_pass+0x4c >>>>> #17 0xffff0000003ea3bc at mi_startup+0x1fc >>>>> uma_zalloc_debug: zone "malloc-128" with the following non-sleepable locks held: >>>>> exclusive sleep mutex LED mtx (LED mtx) r = 0 (0xffff000000d0f6f8) locked @ /usr/src/sys/dev/led/led.c:298 >>>>> stack backtrace: >>>>> #0 0xffff0000004d3dc8 at witness_debugger+0x5c >>>>> #1 0xffff0000004d4fcc at witness_warn+0x400 >>>>> #2 0xffff0000007830a0 at uma_zalloc_debug+0x30 >>>>> #3 0xffff000000782c20 at uma_zalloc_arg+0x2c >>>>> #4 0xffff000000437abc at malloc+0x8c >>>>> #5 0xffff0000007ce1ac at bounce_bus_dmamem_alloc+0xa0 >>>>> #6 0xffff0000008a9404 at bcm2835_mbox_property+0xdc >>>>> #7 0xffff0000008a69e8 at bcm2835_firmware_property+0x78 >>>>> #8 0xffff0000008b1718 at rpi_fw_gpio_pin_set+0xf8 >>>>> #9 0xffff0000001c7400 at led_create_state+0x158 >>>>> #10 0xffff0000001910d4 at gpioled_attach+0x290 >>>>> #11 0xffff00000049efa4 at device_attach+0x3f8 >>>>> #12 0xffff00000049eb14 at device_probe_and_attach+0x7c >>>>> #13 0xffff0000004a0e54 at bus_generic_new_pass+0xfc >>>>> #14 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #15 0xffff0000004a0e04 at bus_generic_new_pass+0xac >>>>> #16 0xffff00000049bd30 at bus_set_pass+0x4c >>>>> #17 0xffff0000003ea3bc at mi_startup+0x1fc >>>>> >>>>> Mike >>>>> >>>> >>>> >>>> -- >>>> Emmanuel Vadot <manu@bidouilliste.com> <manu@freebsd.org> >>>> > > > -- > Emmanuel Vadot <manu@bidouilliste.com> <manu@freebsd.org>