TP-Link TL-WDR4300 Support

[Adrian Chadd]

Hah, looks like the exact same layout as the atheros reference design DB120.


On 2 January 2015 at 15:11, Mike <russiane39 at gmail.com> wrote:
> Hello!
> This is device which probably supported by FreeBSD/MIPS + Atheros drivers.
> Serial console pinout on 4pin connector is:
> Vcc/GND/RX/TX
> To get uboot prompt while router boots you should type "tpl" and press
> enter quickly while uboot outputs "Autobooting in 1 seconds".
> Here is uboot env:
> U-Boot 1.1.4 (Jun 17 2013 - 12:31:57)
>
> U-boot DB120
>
>
> DRAM:  128 MB
> id read 0x100000ff
> flash size 8MB, sector count = 128
> Flash:  8 MB
> Using default environment
>
> PCIe Reset OK!!!!!!
> In:    serial
> Out:   serial
> Err:   serial
> Net:   ag934x_enet_initialize...
> No valid address in Flash. Using fixed address
>  wasp  reset mask:c03300
> WASP  ----> S17 PHY *
> : cfg1 0x7 cfg2 0x7114
> eth0: ba:be:fa:ce:08:41
> athrs17_reg_init: complete
> eth0 up
> eth0
> Autobooting in 1 seconds
> db12x>
> db12x> printenv
> bootargs=console=ttyS0,115200 root=31:02 rootfstype=squashfs
> init=/sbin/init
> mtdparts=ath-nor0:256k(u-boot),64k(u-boot-env),6336k(rootfs),1408k(uImage),64k(mib0),64k(ART)
> bootcmd=bootm 0x9f020000
> bootdelay=1
> baudrate=115200
> ethaddr=0xba:0xbe:0xfa:0xce:0x08:0x41
> ipaddr=192.168.1.111
> serverip=192.168.1.100
> dir=
> lu=tftp 0x80060000 ${dir}u-boot.bin&&erase 0x9f000000 +$filesize;cp.b
> $fileaddr 0x9f000000 $filesize
> lf=tftp 0x80060000 ${dir}db12x${bc}-jffs2&&erase 0x9f050000
> +0x630000;cp.b $fileaddr 0x9f050000 $filesize
> lk=tftp 0x80060000 ${dir}vmlinux${bc}.lzma.uImage&&erase 0x9f680000
> +$filesize;cp.b $fileaddr 0x9f680000 $filesize
> stdin=serial
> stdout=serial
> stderr=serial
> ethact=eth0
>
> Environment size: 686/65532 bytes
> db12x>
>
> --
> With best regards from Russia, Mike