kern/167491: [ath] TID != hardware queue TID in
ath_tx_aggr_comp_aggr()
Adrian Chadd
adrian at freebsd.org
Sat Sep 8 16:14:30 UTC 2012
Hi,
COmpile/run athsurvey; paste the results here.
src/tools/tools/ath/athsurvey/
Adrian
On 8 September 2012 02:50, Alexander Kühn <alexander.kuehn at nagilum.de> wrote:
> The following reply was made to PR kern/167491; it has been noted by GNATS.
>
> From: Alexander =?iso-8859-1?b?S/xobg==?= <alexander.kuehn at nagilum.de>
> To: bug-followup at FreeBSD.org
> Cc:
> Subject: Re: kern/167491: [ath] TID != hardware queue TID in
> ath_tx_aggr_comp_aggr()
> Date: Sat, 08 Sep 2012 11:42:47 +0200
>
> I see the same on x86 along with:
>
> messages.4.bz2:Sep 2 17:04:29 cakebox kernel: ath0: stuck beacon;
> resetting (bmiss count 4)
> messages.4.bz2:Sep 2 17:04:33 cakebox kernel: ath0: stuck beacon;
> resetting (bmiss count 4)
> messages.4.bz2:Sep 2 17:04:33 cakebox kernel: ath0: ath_start:
> sc_inreset_cnt > 0; bailing
> messages.4.bz2:Sep 2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain:
> node 0xc47ea000: bf=0xc350fcc0: addbaw=0, dobaw=0, seqno=0, retry=0
> messages.4.bz2:Sep 2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain:
> node 0xc47ea000: bf=0xc350fcc0: tid txq_depth=1 hwq_depth=0, bar_wait=0
> messages.4.bz2:Sep 2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain:
> node 0xc47ea000: tid 16: txq_depth=64, txq_aggr_depth=0, sched=0,
> paused=0, hwq_depth=0, incomp=0, baw_head=0, baw_tail=0 txa_start=-1,
> ni_txseqs=7
> messages.4.bz2:Sep 2 17:06:25 cakebox kernel: ath0: stuck beacon;
> resetting (bmiss count 4)
>
> Unfortunately this causes the transfer rates to drop and occasionally
> even makes it impossible to associate with the AP.
>
> dmesg:
> Copyright (c) 1992-2012 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
> The Regents of the University of California. All rights reserved.
> FreeBSD is a registered trademark of The FreeBSD Foundation.
> FreeBSD 10.0-CURRENT #0: Wed Aug 29 13:01:13 CEST 2012
> root at cakebox.tis:/usr/obj/export/src/sys/net5501 i386
> CPU: Geode(TM) Integrated Processor by AMD PCS (499.91-MHz 586-class CPU)
> Origin = "AuthenticAMD" Id = 0x5a2 Family = 5 Model = a Stepping = 2
> Features=0x88a93d<FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CLFLUSH,MMX>
> AMD Features=0xc0400000<MMX+,3DNow!+,3DNow!>
> real memory = 536870912 (512 MB)
> avail memory = 515837952 (491 MB)
> K6-family MTRR support enabled (2 registers)
> cryptosoft0: <software crypto> on motherboard
> pcib0 pcibus 0 on motherboard
> pci0: <PCI bus> on pcib0
> Geode LX: Soekris net5501 comBIOS ver. 1.33 20070103 Copyright (C) 2000-2007
> glxsb0: <AMD Geode LX Security Block (AES-128-CBC, RNG)> mem
> 0xa0000000-0xa0003fff irq 10 at device 1.2 on pci0
> vr0: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe100-0xe1ff mem
> 0xa0004000-0xa00040ff irq 11 at device 6.0 on pci0
> vr0: Quirks: 0x2
> vr0: Revision: 0x96
> miibus0: <MII bus> on vr0
> ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
> ukphy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, auto-flow
> vr0: Ethernet address: 00:00:24:cb:a6:80
> vr1: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe200-0xe2ff mem
> 0xa0004100-0xa00041ff irq 5 at device 7.0 on pci0
> vr1: Quirks: 0x2
> vr1: Revision: 0x96
> miibus1: <MII bus> on vr1
> ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
> ukphy1: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, auto-flow
> vr1: Ethernet address: 00:00:24:cb:a6:81
> vr2: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe300-0xe3ff mem
> 0xa0004200-0xa00042ff irq 9 at device 8.0 on pci0
> vr2: Quirks: 0x2
> vr2: Revision: 0x96
> miibus2: <MII bus> on vr2
> ukphy2: <Generic IEEE 802.3u media interface> PHY 1 on miibus2
> ukphy2: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, auto-flow
> vr2: Ethernet address: 00:00:24:cb:a6:82
> vr3: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe400-0xe4ff mem
> 0xa0004300-0xa00043ff irq 12 at device 9.0 on pci0
> vr3: Quirks: 0x2
> vr3: Revision: 0x96
> miibus3: <MII bus> on vr3
> ukphy3: <Generic IEEE 802.3u media interface> PHY 1 on miibus3
> ukphy3: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, auto-flow
> vr3: Ethernet address: 00:00:24:cb:a6:83
> ath0: <Atheros 5416> mem 0xa0010000-0xa001ffff irq 10 at device 14.0 on pci0
> ath0: DMA setup: legacy
> ath0: [HT] enabling HT modes
> ath0: [HT] RTS aggregates limited to 8 KiB
> ath0: [HT] 2 RX streams; 2 TX streams
> ath0: AR5416 mac 13.10 RF2133 phy 8.1
> ath0: 2GHz radio: 0x0000; 5GHz radio: 0x00d0
> isab0: <PCI-ISA bridge> at device 20.0 on pci0
> isa0: <ISA bus> on isab0
> atapci0: <AMD CS5536 UDMA100 controller> port
> 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xe000-0xe00f at device 20.2 on pci0
> ata0: <ATA channel> at channel 0 on atapci0
> ata1: <ATA channel> at channel 1 on atapci0
> ohci0: <OHCI (generic) USB controller> mem 0xa0020000-0xa0020fff irq
> 15 at device 21.0 on pci0
> usbus0 on ohci0
> ehci0: <AMD CS5536 (Geode) USB 2.0 controller> mem
> 0xa0021000-0xa0021fff irq 15 at device 21.1 on pci0
> usbus1: EHCI version 1.0
> usbus1 on ehci0
> cpu0 on motherboard
> orm0: <ISA Option ROM> at iomem 0xc8000-0xd27ff pnpid ORM0000 on isa0
> atrtc0: <AT realtime clock> at port 0x70 irq 8 on isa0
> Event timer "RTC" frequency 32768 Hz quality 0
> attimer0: <AT timer> at port 0x40 on isa0
> Timecounter "i8254" frequency 1193182 Hz quality 0
> Event timer "i8254" frequency 1193182 Hz quality 100
> uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
> uart0: console (19200,n,8,1)
> uart1: <16550 or compatible> at port 0x2f8-0x2ff irq 3 on isa0
> Timecounters tick every 1.000 msec
> usbus0: 12Mbps Full Speed USB v1.0
> usbus1: 480Mbps High Speed USB v2.0
> ugen0.1: <AMD> at usbus0
> uhub0: <AMD OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0
> ugen1.1: <AMD> at usbus1
> uhub1: <AMD EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus1
> ad0: 152627MB <SAMSUNG HM160HC LQ100-10> at ata0-master UDMA100
> GEOM_SCHED: Initializing global data.
> GEOM_SCHED: Loading: mp = 0xc0a9aa20, g_sched_class = 0xc0a9aa20.
> Timecounter "TSC" frequency 499912531 Hz quality 800
> uhub0: 4 ports with 4 removable, self powered
> Root mount waiting for: usbus1
> uhub1: 4 ports with 4 removable, self powered
> _______________________________________________
> freebsd-wireless at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
> To unsubscribe, send any mail to "freebsd-wireless-unsubscribe at freebsd.org"
More information about the freebsd-wireless
mailing list