USB3 SATA enclosure

[Mike Tancsa]

On 12/11/2012 6:49 AM, Hans Petter Selasky wrote:
> On Tuesday 11 December 2012 12:34:11 Mike Tancsa wrote:
>> hw.usb.timings.extra_power_up_time: 20
>> hw.usb.timings.resume_recovery: 50
>> hw.usb.timings.resume_wait: 50
>> hw.usb.timings.resume_delay: 250
>> hw.usb.timings.set_address_settle: 10
>> hw.usb.timings.port_resume_delay: 40
>> hw.usb.timings.port_powerup_delay: 300
>> hw.usb.timings.port_reset_recovery: 250
>> hw.usb.timings.port_root_reset_delay: 250
>> hw.usb.timings.port_reset_delay: 50
> 
> Try to tune these up, one by one.

I doubled them all, and still only

0(cage)# usbconfig
ugen0.1: <EHCI root HUB Intel> at usbus0, cfg=0 md=HOST spd=HIGH
(480Mbps) pwr=SAVE
ugen1.1: <XHCI root HUB 0x1033> at usbus1, cfg=0 md=HOST spd=SUPER
(5.0Gbps) pwr=SAVE
ugen2.1: <EHCI root HUB Intel> at usbus2, cfg=0 md=HOST spd=HIGH
(480Mbps) pwr=SAVE
ugen1.2: <product 0x17ab vendor 0x0b05> at usbus1, cfg=0 md=HOST
spd=HIGH (480Mbps) pwr=ON
ugen1.3: <WinTV HVR-950 Hauppauge> at usbus1, cfg=0 md=HOST spd=HIGH
(480Mbps) pwr=ON
ugen2.2: <product 0x0024 vendor 0x8087> at usbus2, cfg=0 md=HOST
spd=HIGH (480Mbps) pwr=SAVE
ugen0.2: <product 0x0024 vendor 0x8087> at usbus0, cfg=0 md=HOST
spd=HIGH (480Mbps) pwr=SAVE
ugen0.3: <USB 3.0 SATA Bridge VIA Labs, Inc.> at usbus0, cfg=0 md=HOST
spd=HIGH (480Mbps) pwr=ON
ugen0.4: <product 0x1400 vendor 0x04d9> at usbus0, cfg=0 md=HOST spd=LOW
(1.5Mbps) pwr=ON


	---Mike
-- 
-------------------
Mike Tancsa, tel +1 519 651 3400
Sentex Communications, mike at sentex.net
Providing Internet services since 1994 www.sentex.net
Cambridge, Ontario Canada   http://www.tancsa.com/