Network unavailable when booting directly to FreeBSD.

[Sean Bruno]

On Thu, 2012-06-21 at 12:05 -0700, Pedro Giffuni wrote:
> Hello;
> 
> I noticed a regression from 9.0 and I cannot boot directly FreeBSD
> and access the network. Unfortunately I cannot recall the exact
> commit where this started happening.
> 
> uname -a
> FreeBSD pcbsd-8555 9.0-STABLE FreeBSD 9.0-STABLE #12: Wed May 30 
> 11:16:35 PDT 2012 
> root at build9x64.pcbsd.org:/usr/obj/builds/amd64/pcbsd-build90/fbsd-source/9.0/sys/GENERIC 
> amd64
> 
>  From my dmesg
> ______
> ...
> pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
> pcib0: Length mismatch for 4 range: 81 vs 7f
> pci0: <ACPI PCI bus> on pcib0
> pci0: <memory, RAM> at device 0.0 (no driver attached)
> pci0: <memory, RAM> at device 0.1 (no driver attached)
> pci0: <memory, RAM> at device 0.2 (no driver attached)
> pci0: <memory, RAM> at device 0.3 (no driver attached)
> pci0: <memory, RAM> at device 0.4 (no driver attached)
> pci0: <memory, RAM> at device 0.5 (no driver attached)
> pci0: <memory, RAM> at device 0.6 (no driver attached)
> pci0: <memory, RAM> at device 0.7 (no driver attached)
> pcib1: <ACPI PCI-PCI bridge> at device 2.0 on pci0
> pci1: <ACPI PCI bus> on pcib1
> pcib2: <ACPI PCI-PCI bridge> at device 3.0 on pci0
> pci2: <ACPI PCI bus> on pcib2
> bge0: <Broadcom NetXtreme Gigabit Ethernet Controller, ASIC rev. 
> 0x00b002> mem 0xfdef0000-0xfdefffff irq 16 at device 0.0 on pci2
> bge0: CHIP ID 0x0000b002; ASIC REV 0x0b; CHIP REV 0xb0; PCI-E
> miibus0: <MII bus> on bge0
> brgphy0: <BCM5754/5787 1000BASE-T media interface> PHY 1 on miibus0
> brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
> 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, auto, auto-flow
> bge0: Ethernet address: 00:18:8b:76:a4:1e
> pcib3: <ACPI PCI-PCI bridge> at device 4.0 on pci0
> pci3: <ACPI PCI bus> on pcib3
> 
> ....
> Cuse4BSD v0.1.23 @ /dev/cuse
> bge0: watchdog timeout -- resetting
> bge0: watchdog timeout -- resetting
> WARNING: attempt to domain_add(bluetooth) after domainfinalize()
> fuse4bsd: version 0.3.9-pre1, FUSE ABI 7.8
> bge0: watchdog timeout -- resetting
> bge0: link state changed to DOWN
> bge0: link state changed to UP
> bge0: watchdog timeout -- resetting
> bge0: link state changed to DOWN
> bge0: link state changed to UP
> bge0: watchdog timeout -- resetting
> bge0: link state changed to DOWN
> bge0: link state changed to UP
> _____
> 
> Iff I boot Windows first and then reboot to start FreeBSD the network
> works fine.
> 
> Pedro.

I wonder if this is the one that caused your problems?

http://svnweb.freebsd.org/base?view=revision&revision=233495

Can you post the full verbose dmesg and the output of pciconf -lvb for
review?

Sean