KERN - mfi driver for Dell raid h200 on r210 servers

[Damien Fleuriot]

On 29 Jan 2011, at 23:24, "Bjoern A. Zeeb" <bzeeb-lists at lists.zabbadoz.net> wrote:

> On Sat, 29 Jan 2011, Damien Fleuriot wrote:
> 
>> Hello lists,
>> 
>> 
>> I'm trying to get FreeBSD 8.0 or 8.1 to run on a Dell poweredge r210 server.
>> 
>> It ships with a SATA/SAS h200 RAID controller.
>> 
>> 
>> Sadly, the MFI driver doesn't seem to register for this card...
>> 
>> 
>> Find below the pciconf -lcvb
>> 
>> --
>> none6 at pci0:1:0:0:       class=0x010700 card=0x1f1d1028 chip=0x00721000
>> rev=0x02 hdr=0x00
>>   vendor     = 'LSI Logic (Was: Symbios Logic, NCR)'
>>   class      = mass storage
>>   subclass   = SAS
>>   bar   [10] = type I/O Port, range 32, base 0xfc00, size 256, enabled
>>   bar   [14] = type Memory, range 64, base 0xdf2b0000, size 65536, enabled
>>   bar   [1c] = type Memory, range 64, base 0xdf2c0000, size 262144, enabled
>>   cap 01[50] = powerspec 3  supports D0 D1 D2 D3  current D0
>>   cap 10[68] = PCI-Express 2 endpoint max data 256(4096) link x8(x8)
>>   cap 03[d0] = VPD
>>   cap 05[a8] = MSI supports 1 message, 64 bit
>>   cap 11[c0] = MSI-X supports 15 messages in map 0x14
>> --
>> 
>> 
>> I have added the following to /usr/src/sys/dev/mfi/mfi_pci.c at line 119:
>> --
>> {0x1000, 0x0072, 0x1028, 0x1f1e, MFI_FLAGS_GEN2,  "Dell PERC H200 Integrated"},
>> --
> 
> It's 1f1d not 1f1e.  I hope it was only a paste problem into email?
> 

Nope no copy paste problem, I shall try again tomorrow with 1f1d then.
I found this line on the nginx site where the issue was being discussed.

Will post back my results asap.
> 
>>