6.3 nfe: strange behavior after hand

[Andriy Gapon]

on 04/02/2008 05:52 Pyun YongHyeon said the following:
> On Fri, Feb 01, 2008 at 03:56:17PM +0200, Andriy Gapon wrote:
>  > on 01/02/2008 15:42 Andriy Gapon said the following:
>  > > on 01/02/2008 14:36 Pyun YongHyeon said the following:
>  > >> After applying attached patch and let me know the output of
>  > >> "devid : xxx, revid : xxx, pwr = xxx". It would be even better
>  > >> if you can show me the above message for working/non-working case.
>  > >>
>  > >>
>  > > 
>  > > Applied the patch with correction to actually print rev instead of dev
>  > > for the second time :-)
>  > > This is in working case:
>  > > devid : 269, revid : a3, pwr = 00000003
>  > 
>  > A clarification: I just applied the patch, recompiled and re-loaded the
>  > module. There was no reboot/poweroff/reset in between.
>  > 
>  > > Will wait for the non-working situation.
>  > > 
>  > 
> 
> Revert previous patch and try attached patch again and let me know
> how it goes.
> 
> 

Tried it - still no joy, the behavior is as before.
If I gracefully reboot the machine or power down and then up, then
everything is OK. But if I press "reset" button and boot up, the nfe
interface is "dead".
BTW, I kept the line for printing devid/revid/pwr and output is the same
in all cases.

-- 
Andriy Gapon