Panic when ifconfig'ing nge card.

[Peter Losher]

We are rebuilding a system which has a Netgear GA621 (using the nge
driver) installed, and which had run 5.2 & 5.3 pre-releases on amd64
(it's a Dual Opteron box - Tyan Thunder motherboard)

We are now intending to make it a backup server and it is running
5.4-PRE/i386 (cvsupped just under 20 hours ago), and when we try to
configure nge0, after coming up for around 10 seconds it panics.

-=-
nge0: <National Semiconductor Gigabit Ethernet> port 0x9800-0x98ff mem
0xfb8ff000-0xfb8fffff irq 29 at device 1.0 on pci1
nge0: Using TBI
nge0:  1000baseSX, 1000baseSX-FDX, auto
-=-

-=-
% ifconfig fxp0 down
% ifconfig nge0 204.152.187.8 netmask 255.255.255.0
%
%
%
%

Fatal trap 12: page fault while in kernel mode
fault virtual address   = 0x8
fault code              = supervisor read, page not present
instruction pointer     = 0x8:0xc055bdda
stack pointer           = 0x10:0xe97c9c9c
frame pointer           = 0x10:0xe97c9cac
code segment            = base 0x0, limit 0xfffff, type 0x1b
                         = DPL 0, pres 1, def32 1, gran 1
processor eflags        = interrupt enabled, resume, IOPL = 0
current process         = 39 (irq29: nge0)
trap number             = 12
panic: page fault
Uptime: 21m3s
Cannot dump. No dump device defined.
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...
-=-

Any ideas? I have already tried turning of HTT (can't), ACPI (same
effect).  We can't run amd64 since we know the 3ware driver isn't 64-bit
clean and locks up the system under heavy I/O load.  We could just live
w/ 100baseTX, but we would rather be running GigE...

Best Wishes - Peter
--
Peter_Losher at isc.org | ISC | OpenPGP 0xE8048D08 | "The bits must flow"
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 187 bytes
Desc: OpenPGP digital signature
Url : http://lists.freebsd.org/pipermail/freebsd-stable/attachments/20050322/df8e5071/signature.bin