[Bug 218572] pass(4) driver sometimes does error recovery when CAM_PASS_ERR_RECOVER is not set

[bugzilla-noreply at freebsd.org]

https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=218572

--- Comment #2 from commit-hook at freebsd.org ---
A commit references this bug:

Author: ken
Date: Wed May  3 20:59:47 UTC 2017
New revision: 317775
URL: https://svnweb.freebsd.org/changeset/base/317775

Log:
  Fix error recovery behavior in the pass(4) driver.

  After FreeBSD SVN revision 236814, the pass(4) driver changed from
  only doing error recovery when the CAM_PASS_ERR_RECOVER flag was
  set on a CCB to sometimes doing error recovery if the passed in
  retry count was non-zero.

  Error recovery would happen if two conditions were met:

  1.  The error recovery action was simply a retry.  (Which is most
      cases.)
  2.  The retry_count is non-zero. (Which happened a lot because of
      cut-and-pasted code.)

  This explains a bug I noticed in with camcontrol:

  # camcontrol tur da34 -v
  Unit is ready
  # camcontrol reset da34
  Reset of 1:172:0 was successful

  At this point, there should be a Unit Attention:

  # camcontrol tur da34 -v
  Unit is ready

  No Unit Attention.

  Try it again:

  # camcontrol reset da34
  Reset of 1:172:0 was successful

  Now set the retry_count to 0 for the TUR:

  # camcontrol tur da34 -v -C 0
  Unit is not ready
  (pass42:mps1:0:172:0): TEST UNIT READY. CDB: 00 00 00 00 00 00
  (pass42:mps1:0:172:0): CAM status: SCSI Status Error
  (pass42:mps1:0:172:0): SCSI status: Check Condition
  (pass42:mps1:0:172:0): SCSI sense: UNIT ATTENTION asc:29,2 (SCSI bus reset
occurred)
  (pass42:mps1:0:172:0): Field Replaceable Unit: 2

  There is the unit attention. camcontrol(8) has a default
  retry_count of 1, in case someone sets the -E flag without
  setting -C.

  The CAM_PASS_ERR_RECOVER behavior was only broken with the
  CAMIOCOMMAND ioctl, which is the synchronous pass(4) API.  It has
  worked as intended (error recovery is only done when the flag
  is set) in the asynchronous API (CAMIOQUEUE ioctl).

  sys/cam/scsi/scsi_pass.c:
        In passsendccb(), when calling cam_periph_runccb(), only
        specify the error routine when CAM_PASS_ERR_RECOVER is set.

  share/man/man4/pass.4:
        Document that CAM_PASS_ERR_RECOVER is needed to enable
        error recovery.

  Reported by:  Terry Kennedy <TERRY at glaver.org>
  PR:           kern/218572
  MFC after:    1 week
  Sponsored by: Spectra Logic

Changes:
  head/share/man/man4/pass.4
  head/sys/cam/scsi/scsi_pass.c

-- 
You are receiving this mail because:
You are on the CC list for the bug.