SYM8951U sees ch0 but not sa0

[Dan Langille]

On Mar 28, 2014, at 7:33 PM, Matthias Andree <matthias.andree at gmx.de> wrote:
> 
> Am 28.03.2014 22:55, schrieb Dan Langille:
> 
>> I did try swapping the cable and the terminator between the two
>> connectors on the rear of the library.  I ran 'camcontrol rescan all'
>> and 'camcontrol devlist' after each swap.  Never saw the drive.
>> 
>> By daisy-chain things, there are only two connectors on the rear, so I'm
>> not sure what else I could try, other than the above.
> 
> Two are at least two too few.
> 
> Sorry for the pun, I am not trying to make fun here.
> 
> Did you get the library with at least one drive fitted?  Check the
> drawings on pages 21, 199 and 201 in the PDF I mentioned:
>  There should be 2 SCSI connector sockets for the library, and 2 more
> SCSI connector sockets for each tape drive.  So an MSL5026 with two tape
> drives should have six SCSI connectors in total.  They are at the very
> bottom end, possibly hidden under the protruding back part of the
> drives, so be sure to check with the eyes at the same level as the
> bottom of the library.
> 
> HTH
> 

The front panel claims there is a drive installed. I will look closer. But inbet you're right. Thank you. 

-- 
Dan Langille
http://langille.org/