IBM M1015 support

[bsalinux at gmail.com]

I should be able to send you the config tomorrow. I see the card is
dmesg as LSI controller (no driver attached).

I even have tried the mpslsi (from lsi for FreeBSD 8.2).

Thanks

On Sat, Feb 25, 2012 at 12:04 AM, Desai, Kashyap <Kashyap.Desai at lsi.com> wrote:
> Send me your cards PCI config space detail. I generally use "lspci -vvv -s <bus:deviceid>".
> It may possible that your card is part of IBM and might have different pci <vedorid>.
>
> Pls send me card's pci details to comment further.
>
> ` Kashyap
>
>> -----Original Message-----
>> From: owner-freebsd-scsi at freebsd.org [mailto:owner-freebsd-
>> scsi at freebsd.org] On Behalf Of bsalinux at gmail.com
>> Sent: Saturday, February 25, 2012 1:30 PM
>> To: freebsd-scsi at freebsd.org
>> Subject: IBM M1015 support
>>
>> Hello,
>>
>> I'm trying to get M1015 card recognized by FreeBSD 9.0-RELEASE. I have
>> searched the forums but no luck. It seems that the chip LSI SAS2008 is
>> supported by mps driver but couldn't find any results. One of the
>> thread says to flash it with IT firmware but some say that IR is ok
>> also.
>>
>> Any help would be appreciated.
>>
>> Thanks.
>> _______________________________________________
>> freebsd-scsi at freebsd.org mailing list
>> http://lists.freebsd.org/mailman/listinfo/freebsd-scsi
>> To unsubscribe, send any mail to "freebsd-scsi-unsubscribe at freebsd.org"



-- 
NOTICE: This email is a one to one communication and not for receiving
any offers or a mass relay of emails. Please refrain from subscribing
this email address to any of the mailing lists. All / any mass emails
to this address will be considered as SPAM and will be reported to FTC
and other authorities. Thanks.