Adaptec 3405 does not work with FreeBSD 7.0 Generic AMD64
Thomas Vogt
freebsdlists at bsdunix.ch
Tue Mar 4 12:36:00 UTC 2008
Hello List,
I've some problem with an Adaptec 3405 SAS/SATA Raid Controller.
Hardware Release note for 7.0 shows Adaptec SAS RAID 3405 as supported
controller but it looks like its not supported by FreeBSD 7.0 GENERIC
64bit.
When I try to install FreeBSD 7.0 64bit from the install disc1 i got: no
disk found.
I installed FreeBSD on another disk, not connected to the Adaptec
Controller.
7.0-RELEASE FreeBSD 7.0-RELEASE #0: Sun Feb 24 10:35:36 UTC 2008
root at driscoll.cse.buffalo.edu:/usr/obj/usr/src/sys/GENERIC amd64
Boot:
aac0: <Adaptec RAID 3405> mem 0xb8a00000-0xb8bfffff irq 18 at device
14.0 on pci4
aac0: Enabling 64-bit address support
aac0: New comm. interface enabled
aac0: [ITHREAD]
aac0: Adaptec 3405, aac driver 2.0.0-1
aac0: Error 5 sending VMIoctl command
/dev/aac0 is there but I can use it.
arcconf itself works:
arcconf GETCONFIG 1
Controllers found: 1
----------------------------------------------------------------------
Controller information
----------------------------------------------------------------------
Controller Status : Optimal
Channel description : SAS/SATA
Controller Model : Adaptec 3405
Controller Serial Number : 7C2510D73F2
Physical Slot : 6
Temperature : 41 C/ 105 F (Normal)
Installed memory : 128 MB
Copyback : Disabled
Background consistency check : Disabled
Automatic Failover : Enabled
Defunct disk drive count : 0
Logical devices/Failed/Degraded : 1/0/0
--------------------------------------------------------
Controller Version Information
--------------------------------------------------------
BIOS : 5.2-0 (15611)
Firmware : 5.2-0 (15611)
Driver : 0.0-0 (0)
Boot Flash : 5.2-0 (15611)
--------------------------------------------------------
Controller Battery Information
--------------------------------------------------------
Status : Not Installed
----------------------------------------------------------------------
Logical device information
----------------------------------------------------------------------
Logical device number 0
Logical device name : tank
RAID level : Spanned_volume
Status of logical device : Optimal
Size : 2858998 MB
Read-cache mode : Enabled
Write-cache mode : Enabled (write-back)
Write-cache setting : Enabled (write-back)
Partitioned : No
Protected by Hot-Spare : No
Bootable : Yes
Failed stripes : No
--------------------------------------------------------
Logical device segment information
--------------------------------------------------------
Segment 0 : Present (0,0)
Segment 1 : Present (0,1)
Segment 2 : Present (0,2)
Segment 3 : Present (0,3)
----------------------------------------------------------------------
Physical Device information
----------------------------------------------------------------------
Device #0
Device is a Hard drive
State : Online
Supported : Yes
Transfer Speed : SATA 3.0 Gb/s
Reported Channel,Device : 0,0
Vendor : WDC
Model : WD7500AYYS-01RCA
Firmware : 30.04G30
Size : 715404 MB
Write Cache : Enabled (write-back)
FRU : None
S.M.A.R.T. : No
Device #1
Device is a Hard drive
State : Online
Supported : Yes
Transfer Speed : SATA 3.0 Gb/s
Reported Channel,Device : 0,1
Vendor : WDC
Model : WD7500AYYS-01RCA
Firmware : 30.04G30
Size : 715404 MB
Write Cache : Enabled (write-back)
FRU : None
S.M.A.R.T. : No
Device #2
Device is a Hard drive
State : Online
Supported : Yes
Transfer Speed : SATA 3.0 Gb/s
Reported Channel,Device : 0,2
Vendor : WDC
Model : WD7500AYYS-01RCA
Firmware : 30.04G30
Size : 715404 MB
Write Cache : Enabled (write-back)
FRU : None
S.M.A.R.T. : No
Device #3
Device is a Hard drive
State : Online
Supported : Yes
Transfer Speed : SATA 3.0 Gb/s
Reported Channel,Device : 0,3
Vendor : WDC
Model : WD7500AYYS-01RCA
Firmware : 30.04G30
Size : 715404 MB
Write Cache : Enabled (write-back)
FRU : None
S.M.A.R.T. : No
Command completed successfully.
Any ideas?
Regards,
Thomas Vogt
More information about the freebsd-scsi
mailing list