Problem with AIC-7902B Ultra320 SCSI Controller

[artem_kim at inbox.ru]

On Tuesday 30 January 2007 14:56, Anton Yuzhaninov wrote:
> Hello, freebsd-scsi.
>
> At boot time kernel write to logs:
>
> Jan 30 10:35:15 cf2 kernel: Waiting 5 seconds for SCSI devices to settle
> Jan 30 10:35:15 cf2 kernel: ahd1: SCSI Cell parity error SSTAT3 == 0x2
> Jan 30 10:35:15 cf2 kernel: ahd1: Missing case in ahd_handle_scsiint.
> status = 0 Jan 30 10:35:15 cf2 kernel: >>>>>>>>>>>>>>>>>> Dump Card State
> Begins <<<<<<<<<<<<<<<<< Jan 30 10:35:15 cf2 kernel: ahd1: Dumping Card
> State at program address 0x32 Mode 0x33 Jan 30 10:35:15 cf2 kernel: Card
> was paused
> .... [skipped] ...
> Jan 30 10:35:15 cf2 kernel: <<<<<<<<<<<<<<<<< Dump Card State Ends
> >>>>>>>>>>>>>>>>>> Jan 30 10:35:15 cf2 kernel: ahd0: SCSI Cell parity error
> SSTAT3 == 0x2 Jan 30 10:35:15 cf2 kernel: ahd0: Missing case in
> ahd_handle_scsiint. status = 0 Jan 30 10:35:15 cf2 kernel:
> >>>>>>>>>>>>>>>>>> Dump Card State Begins <<<<<<<<<<<<<<<<< Jan 30 10:35:15
> cf2 kernel: ahd0: Dumping Card State at program address 0x2 Mode 0x33 Jan
> 30 10:35:15 cf2 kernel: Card was paused
> .... [skipped] ...
> Jan 30 10:35:15 cf2 kernel: <<<<<<<<<<<<<<<<< Dump Card State Ends
> >>>>>>>>>>>>>>>>>> Jan 30 10:35:15 cf2 kernel: ses0 at ahd0 bus 0 target 6
> lun 0
> Jan 30 10:35:15 cf2 kernel: ses0: <SUPER GEM318 0> Fixed Processor SCSI-2
> device Jan 30 10:35:15 cf2 kernel: ses0: 3.300MB/s transfers
> Jan 30 10:35:15 cf2 kernel: ses0: SAF-TE Compliant Device
> Jan 30 10:35:15 cf2 kernel: da0 at ahd0 bus 0 target 0 lun 0
> Jan 30 10:35:15 cf2 kernel: da0: <FUJITSU MAT3073NC 0108> Fixed Direct
> Access SCSI-3 device Jan 30 10:35:15 cf2 kernel: da0: 320.000MB/s transfers
> (160.000MHz, offset 127, 16bit), Tagged Queueing Enabled Jan 30 10:35:15
> cf2 kernel: da0: 70136MB (143638992 512 byte sectors: 255H 63S/T 8941C) Jan
> 30 10:35:15 cf2 kernel: da1 at ahd0 bus 0 target 2 lun 0
> Jan 30 10:35:15 cf2 kernel: da1: <FUJITSU MAT3073NC 0108> Fixed Direct
> Access SCSI-3 device Jan 30 10:35:15 cf2 kernel: da1: 320.000MB/s transfers
> (160.000MHz, offset 127, 16bit), Tagged Queueing Enabled Jan 30 10:35:15
> cf2 kernel: da1: 70136MB (143638992 512 byte sectors: 255H 63S/T 8941C)
>
> ahd0 at pci2:3:0:  class=0x010000 card=0x081115d9 chip=0x801d9005 rev=0x10
> hdr=0x00 vendor   = 'Adaptec Inc'
>     device   = 'AIC-7902B Ultra320 SCSI Controller'
>     class    = mass storage
>     subclass = SCSI
>
> 6.2-RELEASE i386
>
> Full log at http://pastebin.com/871132
>
> Is there any problem with controller or driver?

I had similar problems with Supermicro X6DHR-8G2 and FreeBSD 5.4 (ia32).
The system was started, if I used "safe mode" or "hint.apic.0.disabled=1" in 
loder.conf.

But the correct decision of a problem in my case was updating BIOS of a MB.


-- 
Аrtem Kim
mailto: artem_kim at inbox.ru