qlogic isp 6312 device not showing up

[jason kawaja]

On Thu, 23 Mar 2006, jason kawaja wrote:

> after getting the scsi errors resolved on the remote fc device, the 
> problem remains so i am going to replace the current qla200 card with 
> qla23xx to see if the fc device can then be seen by freebsd.  (the 
> qla23xx card previously worked on a similar freebsd system.)

indeed the qla23xx card works (disk device shows up within freebsd) when 
the same fc device was unable to to work with the qla200 card (no 
changes to freebsd system/kernel).

isp0: <Qlogic ISP 2312 PCI FC-AL Adapter> port 0x4000-0x40ff mem 
0xdefff000-0xdeffffff irq 96 at device 4.0 on pci4
isp0: [GIANT-LOCKED]
isp0: bad execution throttle of 0- using 16
isp0: bad hard address 125- resetting to zero

<snip>

da0 at isp0 bus 0 target 0 lun 0
da0: <IBM 2105800 .124> Fixed Direct Access SCSI-3 device
da0: 200.000MB/s transfers, Tagged Queueing Enabled
da0: 953MB (1953152 512 byte sectors: 64H 32S/T 953C)

cant say i like the fact that the fc disk get assigned as da0 causing my 
local scsi devices to get bumped (require /etc/fstab alterations) but 
that appears in linux as well so is not likely freebsd related.

--
Jason Kawaja 2-4568
http://www.ietf.org/rfc/rfc1855.txt