CISS RAID recovering turns back to ready to recovery

[tonix (Antonio Nati)]

I've to correct previous e-mail.

Recovering after rebooting works perfectly. The strange behaviour was 
due to more disks being faulty. Repeating the test with "upright" 
units all problems disappear.

Tonino

At 10.32 28/09/2005, you wrote:

>I'm testing CISS driver (Proliant DL580 G1, Smart Array 5300/128 
>V3.54, FreeBSD 5.4 cvsup'd to latest stable) simulating drives 
>crashing and following rebuilding of RAID set.
>
>With raid 0+1 all is handled nicely, except when rebooting.
>
>When extracting and inserting back a drive, all signals from driver 
>are OK, and RAID start to rebuild itself (status is "Recovering"), 
>but after rebooting status changes and turns back to:
>
>         pass0: <COMPAQ RAID 1  VOLUME read> Fixed Direct Access SCSI-0 device
>
>That means "ready to begin recovery".
>
>So, how to handle correctly recovery?
>
>Tonino
>
>
>_______________________________________________
>freebsd-scsi at freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-scsi
>To unsubscribe, send any mail to "freebsd-scsi-unsubscribe at freebsd.org"