ZFS and replaced motherboard

[Grzegorz Junka]

I have replaced a motherboard with almost an identical (the new one only 
doesn't have a LSI SAS2 controller, which wasn't used anyway).

So, I was surprised to see that ZFS automatically recognized the pool 
after I booted up the system on the new motherboard despite the fact 
that accidentally some SATA ports have been swapped (i.e. disks weren't 
connect to the same SATA ports as on the old motherboard).

However, there is one thing that differs from the old system and that's 
how those disks are reported:

         NAME                               STATE     READ WRITE CKSUM
         tank1                              ONLINE 0     0     0
           raidz2-0                         ONLINE 0     0     0
             diskid/DISK-WD-WCC1U3689037p3  ONLINE 0     0     0
             diskid/DISK-WD-WCC1U3680535p3  ONLINE 0     0     0
             diskid/DISK-WD-WCC1U4178255p3  ONLINE 0     0   336
             diskid/DISK-WD-WCC1U4176715p3  ONLINE 0     0     0
             diskid/DISK-WD-WCC1U3531030p3  ONLINE 0     0     0
             diskid/DISK-WD-WCC1U3565183p3  ONLINE 0     0     0

Ignore the checksum error, that's because one disk wasn't connected 
properly for a couple of minutes but then was reconciled. The issue is 
that these disks no longer show as ada1, ada2, ada3, ada4, ada5, ada6. Why?

The same with the M.2 nvm-e disks:

         NAME                            STATE     READ WRITE CKSUM
         tank5                           ONLINE       0     0     0
           mirror-0                      ONLINE       0     0     0
             diskid/DISK-S1XXNYAH300115  ONLINE       0     0     0
             diskid/DISK-S1XXNYAH300143  ONLINE       0     0     0

They should be showing as nvd0 and nvd1. How to correct this? Does this 
need to be corrected?

GrzegorzJ