7.2 burncd and cdrecord problem

[Fernando Apesteguía]

On Sat, Aug 15, 2009 at 12:20 PM, Ruben de Groot<mail25 at bzerk.org> wrote:
> On Fri, Aug 14, 2009 at 08:23:49PM +0200, Fernando Apestegu?a typed:
>> Hi all,
>>
>> I'm trying to get my CD drive to work without so much success.
>> Reading is fine, but when I try to burn a CD I get errors in dmesg.
>>
>> Using cdrecord -blank=fast dev=3,0,0 I get:
>>
>> [...]
>> Using generic SCSI-3/mmc   CD-ROM driver (mmc_cd).
>> Driver flags   : MMC-3 SWABAUDIO BURNFREE
>> Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
>> Starting to write CD/DVD at speed 18 in real BLANK mode for single session.
>> Last chance to quit, starting real write    0 seconds. Operation starts.
>> This drive or media does not support the 'BLANK media' command
>> cdrecord: Cannot blank disk, aborting.
>> cdrecord: Some drives do not support all blank types.
>> cdrecord: Try again with cdrecord blank=all.
>
> So what happened when you tried the blank=all option instead of your blank=fast?
> You did try that, didn't you?

I did, sorry I didn't mention that. It shows the same errors.

>
> Ruben
>
>