sata: setfeatures settransfermode taskqueue timeout

[Derek Ragona]

At 12:34 PM 7/19/2007, Harry Newton wrote:
>Steve
>
>Check your cables: I had similar sporadic failures which were caused
>by a SATA cable that didn't seat well into the sockets on the board
>and drive. When I replaced the cable with a better one with a spring
>clip the failures stopped.
>
>  - Harry

My most recent SATA problems were cables too.  Not sure why the cables went 
bad, but the drives would just detach on the old cables.

         -Derek

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.