installed perl 5.8. from the ports ??

[Murray Taylor]

did you enter the command 

use.perl port

after installing perl 5.8 _before_ rebuilding rt3 ?? Perl by default
will continue to use the perl supplied with the initial site distro...

to switch back it 
use.perl site

mjt



On Fri, 2004-05-21 at 13:51, Shawn Guillemette wrote:
> I needed to install something better then perl 5.6.1 in order to install 
> something from another port. So I did a locate on perl and 
> found /usr/ports/lang/perl5.8  So I cd to the dir and make install and after 
> it completed with no errors the I go back to the port I was attempting to 
> install and I get the same message: 
> 
>  rt3-3.0.9 This program only support perl 5.6.1 or above.
> 
> Unfortunately I dont know what version I has using before. I was wondering if 
> there was somthign I needed to do to stop using the older version and start 
> using the new one?
> 
> 
> --
> Shawn Guillemette
> 
> _______________________________________________
> freebsd-questions at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-questions
> To unsubscribe, send any mail to "freebsd-questions-unsubscribe at freebsd.org"
> 
> ************************************************************************
> This Email has been scanned for Viruses by MailMarshal.
> ************************************************************************
-- 
Murray Taylor
Special Projects Engineer
---------------------------------
Bytecraft Systems & Entertainment
P: +61 3 8710 2555
F: +61 3 8710 2599
D: +61 3 9238 4275
M: +61 417 319 256
E: murraytaylor at bytecraftsystems.com
or visit us on the web
http://www.bytecraftsystems.com
http://www.bytecraftentertainment.com



************************************************************************
This Email has been scanned for Viruses by MailMarshal.
************************************************************************