Pen drive does not work with PCI2USB card.

[Eugene Savin]

On Sat, Jun 14, 2003 at 10:11:12AM +0200, Bernd Walter wrote:
> On Sat, Jun 14, 2003 at 11:23:20AM +0400, Eugene Savin wrote:
> > Hi,
> > I have USB 2.0 PCI Card GMU2P-04V, pen drive ("Mobile Disk III" from TwinMOS
> > FreeBSD 4.8.
> >
> > Part of my kernel conf. file:
> >   ...
> >   device          scbus           # SCSI bus (required)
> >   device          da              # Direct Access (disks)
> >   device          da0
> >   device          pass            # Passthrough device (direct SCSI access)
> >   ...
> >   device          uhci            # UHCI PCI->USB interface
> >   device          ohci            # OHCI PCI->USB interface
> >   device          usb             # USB Bus (required)
> >   device          ugen            # Generic
> > Part of dmesg:
> >   ...
> >   uhci0: <VIA 83C572 USB controller> port 0x6400-0x641f irq 12 at device 11.
> >   usb0: <VIA 83C572 USB controller> on uhci0
> >   usb0: USB revision 1.0
> >   uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
> >   uhub0: 2 ports with 2 removable, self powered
> >   uhci1: <VIA 83C572 USB controller> port 0x6500-0x651f irq 11 at device 11.
> >   ...
> >   usb1: <VIA 83C572 USB controller> on uhci1
> >   usb1: USB revision 1.0
> >   uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
> >   uhub1: 2 ports with 2 removable, self powered
> >   pci0: <USB controller> at 11.2 irq 10
> >   ...
> >
> > I have usbd_enable="YES" in /etc/rc.conf.
> > Inserting of my pen drive in card does not get any effect.
> > When I use my pen drive on othe computer (with integrated USB Host Controlle
> > usbd detect da0 disk.
>
> Does it make a difference if the device is already plugged in while
> booting?
No, it doesn't.
When I use pen drive in other machines with embeded USB host controller, I
have in my dmessg:
da0 at umass-sim0 bus 0 target 0 lun 0
da0: <Easy Disk 1.11> Removable Direct Access SCSI-2 device
da0: 650KB/s transfers
da0: 251MB (515840 512 byte sectors: 64H 32S/T 251C)