[pf4freebsd] Re: Problems with nat on xl0

[Brent Bolin]

That was exactly the problem.  Userland was built with -

/etc/make.conf
NOINET6=true

But /sys/i386/conf/GENERIC had -

options        INET6                   #IPv6 communications protocols

So the moral of the story is if /etc/make.conf compiles userland without IP6
but the kernel config file has it, the kernel config file overrides.

I have been running this config on a number of 5.2.1 systems with no
problem.  So for testing purposes to the developers this config appears to
work fine.

I prefer to run without IP6

Thanks for your reply.

btb

-----Original Message-----
From: pf4freebsd-bounce at freelists.org
[mailto:pf4freebsd-bounce at freelists.org]On Behalf Of Lukasz Bromirski
Sent: Monday, July 26, 2004 5:06 PM
To: pf4freebsd at freelists.org
Subject: [pf4freebsd] Re: Problems with nat on xl0


Brent Bolin wrote:

> Just cvsup 5.2.1_RELEASE and update ports to current
> Not able to run nat on xl0
> pfctl: DIOCADDADDR: Address family not supported by protocol family

You did build and install a kernel with

options         INET6

in it, didn't You?

--
this space was intentionally left blank    |          ?ukasz Bromirski
you can insert your favourite quote here   |      lukasz:bromirski,net