Can't make FreeBSD to see my usb mass drive

[Даниял Гулиев]

I've got FreeBSD 5.2.1. There's all nesessary options in kernel as it said in handbook (http://www.freebsd.org/doc/en_US.ISO8859-1/books/handbook/usb-disks.html). Friendly speaking all the possible USB options was turned on in default GENERIC configuration.

usbd is running - I can see it when I run "top".

When I plug in usb-flash there's _no_ kernel messages in console, no "GEOM: create disk da0 dp=0xc2d74850" etc. 

"usbdevs" shows:

>>addr1 UHCI root hub, Intel 
>>addr0 : should never happen! 

In 30 seconds kernel throws the following message:

>>uhub0: device problem, disabling port 1

When I run FreeBSD LiveCD (called "Frenzy", based on 4.x) I can work with that usb-flash without any problems. Thus there's no hardware problems.

I've compared /etc/rc.conf and /etc/usbd.conf at my FreeBSD and "Frenzy". No differences. I can't understand, where's the problem?