bxe + if_lagg

[Tom Judge]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 10/31/12 3:47 AM, YongHyeon PYUN wrote:
> On Tue, Oct 30, 2012 at 11:23:37AM -0400, Tom Judge wrote:
> 
> [...]
> 
>> I am trying to get if_lagg working in an HP blade for failover
>> between the 2 in chassis cisco switches, but it would seem that
>> the link state is not being propagated up to the lagg device.
>> 
>> Any hints/ideas?
>> 
>> 
>> 
>> dmesg: bxe1: <Broadcom NetXtreme II BCM57711E 10GbE (A0) BXE
>> v:1.5.52 bxe1: Ethernet address: 00:25:b3:a8:76:e4 bxe1: ASIC
>> (0x16500000); Rev (A0); Bus (PCIe x4, 5Gbps); Flags (MSI-X);
>> Queues (RSS:16); BD's (RX:510,TX:255); Firmware (5.2.13); 
>> Bootcode (4.8.0)
>> 
> 
> Try attached patch and let me know whether it makes any
> difference.
> 

This results in zero network connectivity, even with an IP assigned to
the bxe device directly.

It does show status: active and the same 10Gbase-SR media however.

Ping results in no route to host.


Tom

- -- 
FreeBSD Ports Committer
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.12 (Darwin)
Comment: Using GnuPG with Mozilla - http://www.enigmail.net/

iQEcBAEBAgAGBQJQkUxRAAoJEEJSM9yB4iIWPQQH/A2Irw0B9YHElcGBYZ+LMWaD
O4/MLbK5xUFlMTHghwEFEHBvvPpY6wiz8B0qNxs6t86wd6TwgWn3TVyRAow3VBHO
2ePtfFmGoo5P6i2oXApTu8EN+MXkDcHuxsHtkrYk5ZXRDTAT9Bs7jZLNCBOxB2RB
LPla89xBtTMBhgTMuzBGdS0DQz54r22puvuHemHgmAr0IzgXnNO+0OVFd7TN0iPG
rVFu5A5rUjeWYM0oKJUt29CgE6+x4aUrYABLgm3EByaCTi4ifFN1Ua7aUGZx2Nzn
SNmsoccufnX6x2XX8/1K5cv66jBpQnkaxq+lWMRovQRsFxuCymEG+9Hp58OCrXU=
=PzdL
-----END PGP SIGNATURE-----