bxe + if_lagg

[Tom Judge]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1



I am trying to get if_lagg working in an HP blade for failover between
the 2 in chassis cisco switches, but it would seem that the link state
is not being propagated up to the lagg device.

Any hints/ideas?



dmesg:
bxe1: <Broadcom NetXtreme II BCM57711E 10GbE (A0) BXE v:1.5.52
bxe1: Ethernet address: 00:25:b3:a8:76:e4
bxe1: ASIC (0x16500000); Rev (A0); Bus (PCIe x4, 5Gbps); Flags
(MSI-X); Queues (RSS:16); BD's (RX:510,TX:255); Firmware (5.2.13);
Bootcode (4.8.0)



bxe1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0
mtu 1500
options=1bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4>
	ether 00:25:b3:a8:76:e4
	nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
	media: Ethernet autoselect (10Gbase-SR <full-duplex>)
	status: active

lagg0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0
mtu 1500
options=1bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4>
	ether 00:25:b3:a8:76:e4
	nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
	media: Ethernet autoselect
	status: no carrier
	laggproto failover
	laggport: bxe1 flags=1<MASTER>
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.12 (Darwin)
Comment: Using GnuPG with Mozilla - http://www.enigmail.net/

iQEcBAEBAgAGBQJQj/D5AAoJEEJSM9yB4iIWxG4H/250zytRh6knhMPlml/fRh5V
0pwUMA/kFR6+8Ov4LU5o0NMzaFJ7OpwLILgmyxup8xP6XIcxmVkuK72X0h+wYB+6
aVLyGPiqro7lDj4SPFQOO6KxXghZf41O0dwjrUxf7cHIZRGAyQd0c+L4i+r4Q6g4
HJQqNZ+M7x6MBvyhA3T53IvXtPVxXbHw/D5gK3Y92HtoiIAaSaaaDBA2wEg2q8Pi
pwXXTkAklwsMQpJzoRuRdWjud1VunH5PQ6uvfi5Wp5ldmyH1c2BtZ0gech09sMar
xV/INBNc2xijBxX/Cv7hx3JbUOCGFg/t8i5gD5jxYgpiXXJ/WMU/6oxWFcFQaD8=
=bk5c
-----END PGP SIGNATURE-----