[Solved] Re:Commands for AR5212 cause system to hang using 8.2-STABLE

[Adrian Chadd]

On 2 September 2011 11:43, Martes G Wigglesworth
<mailinglistmember at mgwigglesworth.net> wrote:

>
> However, all works perfectly, if I simply assign the intended ip address to
> the wlan0 device.
>
> Any input on this?

I don't have anything useful to add; but then I don't use hostap mode
with an IP address on the wlan interface. I tend to dump the hostap
wlan interfaces into a bridge group.

You'll likely have to go digging into the network scripts a bit.

Also, you likely shouldn't have " "'s around the ssid.


Adrian