kern/123053: [re] re(4) unsupported hardware revision

[Mark Linimon]

The following reply was made to PR kern/123053; it has been noted by GNATS.

From: linimon at lonesome.com (Mark Linimon)
To: bug-followup at FreeBSD.org
Cc:  
Subject: Re: kern/123053: [re] re(4) unsupported hardware revision
Date: Fri, 25 Apr 2008 05:17:45 -0500

 ----- Forwarded message from Eric F Crist <ecrist at secure-computing.net> -----
 
 From: Eric F Crist <ecrist at secure-computing.net>
 To: linimon at FreeBSD.org
 Subject: kern/123053
 Cc: freebsd-drivers at freebsd.org
 
 Andrey,
 
 I've applied the patch to a 7.0-RELEASE-p1 source tree and rebooted my  
 system.  The card comes UP ok, but shows the following when connected  
 to a 100BaseT/ Full Duplex switch port:
 
 re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
 	options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM>
 	ether 00:1f:c6:52:7b:80
 	media: Ethernet autoselect (10baseT/UTP <half-duplex>)
 	status: active
 
 Once I've assigned an IP to the interface, however, it comes up  
 correctly and seems to function just fine.  Is there any load testing  
 I should perform for you folks?
 
 re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu  
 1500
 	options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM>
 	ether 00:1f:c6:52:7b:80
 	inet 10.0.0.38 netmask 0xffff0000 broadcast 10.0.255.255
 	media: Ethernet autoselect (100baseTX <full-duplex>)
 	status: active
 
 -----
 Eric F Crist
 Secure Computing Networks
 
 ----- End forwarded message -----