[D800] Dell D800 (FBSD 5.2-release) Broadcom BCM5705M MTU/Jumbo Problem

[Eric Anderson]

David Gilbert wrote:

>>>>>>"Eric" == Eric Anderson <anderson at centtech.com> writes:
>>>>>>            
>>>>>>
>
>Eric> As a data point, my BCM5702 (Dell D600) works fine: # ifconfig
>Eric> -a bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu
>Eric> 9000 options=1b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING> inet6
>Eric> fe80::20b:dbff:fea3:f9a1%bge0 prefixlen 64 scopeid 0x1 inet
>Eric> 0.0.0.0 netmask 0xff000000 broadcast 255.255.255.255 ether
>Eric> 00:0b:db:a3:f9:a1 media: Ethernet autoselect (none) status: no
>Eric> carrier
>
>What is the probe line for your bge?
>
>Mine is:
>
>bge0: <Broadcom BCM5705M Gigabit Ethernet, ASIC rev. 0x3001> mem 0xfaff0000-0xfaffffff irq 11 at device 0.0 on pci2
>bge0: Ethernet address: 00:0b:db:94:3d:01
>miibus0: <MII bus> on bge0
>  
>
bge0: <Broadcom BCM5702 Gigabit Ethernet, ASIC rev. 0x1002> mem 
0xfaff0000-0xfaffffff irq 11 at device 0.0 on pci2
bge0: Ethernet address: 00:0b:db:a3:f9:a1
miibus0: <MII bus> on bge0
brgphy0: <BCM5703 10/100/1000baseTX PHY> on miibus0
brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX, 
1000baseTX-FDX, auto

Strange - it shows BCM5702, then BCM5703

Eric


-- 
------------------------------------------------------------------
Eric Anderson     Sr. Systems Administrator    Centaur Technology
Today is the tomorrow you worried about yesterday.
------------------------------------------------------------------