Lots of input errors...

[Shawn Ramsey]

> > Ok.. It is set hard to 100BT/FD on both ends. I don't know if you saw
this,
> > but since resetting the stats a few hours ago, it shows no errors at all
on
> > their end, but were still getting errors on our end... The CRC and frame
> > errors could have been from a media mismatch when things were first
setup.
> > Im not sure if the stats have ever been reset. Assuming the errors stay
at
> > zero on their end, any ideas? Am going to try another server/router, and
if
> > things look better, start replacing hardware on this router...
> >
>
> I would say the physical wire is probably bad.  Seeing unidirectional
errors
> in this case wouldn't be uncommon; one of the pair of the receive wires
may
> have issues.  Have you swapped the cable?  Most of the time you won't see
> framing errors related to duplex mismatching.
>
> Also, although this sounds contrary to sane thinking about hard coding of
> duplex and speed, the Cisco will do better autosensing if you are using an
> Intel ethernet card on the server.  I'm not sure why, but I've seen this
> happen in the past.

Im not sure if I asked this, but assuming the cable is bad, could this be
causing the very high interupt usage we are seeing?