baresip (was Re: Ekiga && FreeBSD (for a future without Skype)

[Chris Rees]

On 3 September 2012 13:51, Matthias Apitz <guru at unixarea.de> wrote:
> El día Monday, September 03, 2012 a las 01:39:47PM +0100, Chris Rees escribió:
>
>> Oh dear... that's the problem.  As Matthias has pointed out, the libs must
>> be in /usr/lib32.
>>
>> The other problem is that you're obviously not running CURRENT, so
>> Matthias's libssl version does not match yours.
>
> yes;
>
>>
>> Matthias, did you get v4l2 working, and if so, how?
>
> I have the following lines in the config:
>
> $ egrep 'video|v4' .baresip/config
> video_dev               /dev/video0
> video_size              352x288
> video_bitrate           384000
> video_fps               25
> #video_selfview         window # {window,pip}
> module                  v4l2.so
> #module                 v4l.so
>
> and when I press 'v' it starts the video loop as:
>
> Enable video-loop on /dev/video0: 352 x 288
> v4l2: open video source: 352 x 288
> /dev/video0: found valid V4L2 device (352 x 288) pixfmt=YU12
> Current input: Camera 1
>
> and I can seeme fine;
>
> as I said, I compiled v0.4.0 directly from the sources, just the normal way:
>
> $ ./configure
> $ make
> # make install
>
> I do not remember (and can't check it now) if I set some special flags
> in ./configure, will check later at home;
>

The port now supports V4L2 and PORTAUDIO as well, after investigation
and sharing code.

Beer is owed to Matthias for doing the real work!

Chris