Atheros and how to convert RSSI to dBm

[Miroslav Chlastak]

On 27.5.2010 10:23, Rui Paulo wrote:

>  On 27 May 2010, at 08:58, Miroslav Chlastak wrote:
>
>
>>  On 27.5.2010 02:16, Rui Paulo wrote:
>>
>>>  On 26 May 2010, at 23:25, Miroslav Chlastak wrote:
>>>
>>>
>>>
>>>>  Hello,
>>>>
>>>>    is there a way how to convert RSSI from output of "ifconfig ath0 list sta" to dBm?:
>>>>
>>>>  [snip]
>>>>
>>>>  ADDR               AID CHAN RATE RSSI IDLE  TXSEQ  RXSEQ CAPS FLAG
>>>>  00:4f:62:1d:d8:5d   14    9  11M 18.5    0  15932  22400 ES   A
>>>>
>>>>  [snip]
>>>>
>>>>  I my test enviroment I use this function:
>>>>  noise floor + RSSI*2 = signal of client in dBm
>>>>
>>>>  Then i get the same value as from "tcpdump -n -i ath0 -p -y IEEE802_11_RADIO":
>>>>
>>>>  [snip]
>>>>
>>>>  10:41:04.746395 86402611933us tsft short preamble 58.5 Mb/s -61dB signal -98dB noise antenna 1 [0x00000012] IP 10.0.0.1.2049>    192.168.100.2.123: NTPv3, Client, length 48
>>>>
>>>>  [snip]
>>>>
>>>>
>>>>  Right? Or is this conversion "stupid"? Some better idea?
>>>>
>>>>  Is there a way how to get noise floor via "ifconfig"? I get it from output of "athstats" :(
>>>>
>>>>
>>>  No, there's no way right now.
>>>
>>>  Check this: http://lists.freebsd.org/pipermail/freebsd-stable/2006-September/028895.html
>>>
>>>  Regards,
>>>  --
>>>  Rui Paulo
>>>
>>>
>>>
>>>
>>  But this mail was sent on September 2006 - it's still impossible? :(
>>
>>  And how to do it tcpdump?
>>
>>  tcpdump -n -i ath0 -p -y IEEE802_11_RADIO":
>>
>>  [snip]
>>
>>  10:41:04.746395 86402611933us tsft short preamble 58.5 Mb/s -61dB signal -98dB noise antenna 1 [0x00000012] IP 10.0.0.1.2049>    192.168.100.2.123: NTPv3, Client, length 48
>>
>>  [snip]
>>
>>
>>  Signal -61dB is right signal of my connected wireless client. Tcpdump this signal "know", but system (via ifconfig) doesn't?
>>
>  Yes, that's right. The changes were not done yet to support displaying this data in ifconfig. It's not hard to change ifconfig, what's hard is changing every driver to provide useful info. ath passes this information to radiotap the same way it provides this information to athstats.
>
>  Regards,
>  --
>  Rui Paulo
>
>
>

And why not display a new column name "Signal"? Card with "supported
features" display right signal of wireless client and others display "NaN"?

Atheros drivers have this support? Is my converting algoritmus right for
ath devices (noise floor + RSSI*2 = signal of wireless client in dBm)?

-- 
Mira Chlastak