RFC: PCI SD host controller driver & mmc/mmcsd modules improvements

[Carlos A. M. dos Santos]

On Sat, Sep 27, 2008 at 6:26 PM, Oleksandr Tymoshenko
<gonzo at bluezbox.com> wrote:
> Alexander Motin wrote:
>>
>> Hi.
>
>>
>> Latest patches against 8-CURRENT (should also fit 7-STABLE) may be found
>> at:
>> http://people.freebsd.org/~mav/sdhci/
>
>    Thanks! That's just what I was looking for about three weeks ago :)
>>
>> I will be grateful for any feedbacks, comments and support.
>
> 7.1 requires s/kproc/kthread/ but otherwise works fine:
>
> sdhci0: <RICOH R5C822 SD> mem 0xff9fb800-0xff9fb8ff irq 9 at device 1.2 on
> pci2
> sdhci0: 1 slot(s) allocated
> sdhci0: [ITHREAD]
>
> mmc0: <MMC/SD bus> on sdhci0
> mmc0: SD card: 507379712 bytes
> mmcsd0: 483MB <MMC/SD Memory Card> (read-only) at mmc0
> mmc0: setting transfer rate to 30.000MHz
> mmc0: setting bus width to 4 bits
> GEOM_LABEL: Label for provider mmcsd0s1 is msdosfs/SD.

It did not detect the hardware on my Compaq 6910p:

none2 at pci0:2:6:3:	class=0x080500 card=0x30be103c chip=0x08221180
rev=0x20 hdr=0x00
    vendor     = 'Ricoh Company, Ltd.'
    device     = 'R5C832, R5C843 SDA Standard Compliant SD Host Controller'
    class      = base peripheral
none3 at pci0:2:6:4:	class=0x088000 card=0x30be103c chip=0x08431180
rev=0x10 hdr=0x00
    vendor     = 'Ricoh Company, Ltd.'
    device     = 'unknown Ricoh MMC Host Controller'
    class      = base peripheral

Suggestions are welcome. :-)

-- 
cd /usr/ports/sysutils/life
make clean