[Wireless] Can't connect to wlan

[Alphons "Fonz" van Werven]

Benjamin Close wrote:

> Yes the releng_7 one is for 7.

Okay,

The patch has been applied (laptop running 7.0-RELEASE) and all modules
loaded:

# kldload if_wpi
wpi0: <Intel(R) PRO/Wireless 3945ABG> mem 0xd8000000-0xd8000fff irq 17 at 
device  0.0 on pci4
wpi0: Ethernet address: 00:1b:77:b5:98:bd
wpi0: [ITHREAD]
#kldload wpifw
#kldload wlan_xauth

The license ack was still in my loader.conf, so that's ok too.
However: with the patch applied, wpi can't even seem to find any APs
anymore, let alone associate with them.

I included the output of wpa_supplicant below, in case it's of any help.

Regards,

Alphons

# wpa_supplicant -d -i wpi0 -c /etc/wpa_supplicant.conf
Initializing interface 'wpi0' conf '/etc/wpa_supplicant.conf' driver 
'default' c
trl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant.conf'
Priority group 0
    id=0 ssid='SpeedTouch1EC5E8'
Initializing interface (2) 'wpi0'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
Own MAC address: 00:1b:77:b5:98:bd
wpa_driver_bsd_set_wpa: enabled=1
wpa_driver_bsd_set_wpa_internal: wpa=3 privacy=1
wpa_driver_bsd_del_key: keyidx=0
wpa_driver_bsd_del_key: keyidx=1
wpa_driver_bsd_del_key: keyidx=2
wpa_driver_bsd_del_key: keyidx=3
wpa_driver_bsd_set_countermeasures: enabled=0
wpa_driver_bsd_set_drop_unencrypted: enabled=1
Setting scan request: 0 sec 100000 usec
Added interface wpi0
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Trying to get current scan results first without requesting a new scan to 
speed
up initial association
Received 0 bytes of scan results (0 BSSes)
Scan results: 0
Selecting BSS from priority group 0
Try to find WPA-enabled AP
Try to find non-WPA AP
No suitable AP found.
Setting scan request: 0 sec 0 usec
Starting AP scan (broadcast SSID)
wpi0: timeout resetting Tx ring 1
wpi0: timeout resetting Tx ring 3
wpi0: timeout resetting Tx ring 4
Received 0 bytes of scan results (0 BSSes)
Scan results: 0
Selecting BSS from priority group 0
Try to find WPA-enabled AP
Try to find non-WPA AP
No suitable AP found.
Setting scan request: 5 sec 0 usec

[repeat the following until out of patience]

Starting AP scan (broadcast SSID)
Received 0 bytes of scan results (0 BSSes)
Scan results: 0
Selecting BSS from priority group 0
Try to find WPA-enabled AP
Try to find non-WPA AP
No suitable AP found.
Setting scan request: 5 sec 0 usec
Starting AP scan (broadcast SSID)
Received 0 bytes of scan results (0 BSSes)
Scan results: 0
Selecting BSS from priority group 0
Try to find WPA-enabled AP
Try to find non-WPA AP
No suitable AP found.
Setting scan request: 5 sec 0 usec

[okay, I'm out of patience now, so I ^C it]

CTRL-EVENT-TERMINATING - signal 2 received
Removing interface wpi0
State: SCANNING -> DISCONNECTED
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
wpa_driver_bsd_set_wpa: enabled=0
wpa_driver_bsd_set_wpa_internal: wpa=0 privacy=0
wpa_driver_bsd_set_drop_unencrypted: enabled=0
wpa_driver_bsd_set_countermeasures: enabled=0
No keys have been configured - skip key clearing
Cancelling scan request
Cancelling authentication timeout
wpa_driver_bsd_set_wpa_internal: wpa=0 privacy=1

-- 
All right, that does it Bill [Donahue]. I'm pretty sure that killing Jesus
is not very Christian.
                              -- pope Benedict XVI, South Park episode #158