Dell Inspirion 1300 doesn't wake up

[Dennis Melentyev]

Kind of status update:

Installed yesterday's RC2 - suspension/resuming work Ok. With 2
seconds delay and sysctl hw.acpi.video.lcd0.active=1 in rc.restore.

Great!

With binary sound driver from URL below (as of Dec, 23rd) - it does
not survive S3 suspension/resuming, writting series of these string
into xconsole:

pcm0: timeout in reset
pcm0: hdac_command_send_internal: TIMEOUT numcmd=1, sent=1, received=0
pcm0: hdac_command_send_internal: TIMEOUT numcmd=1, sent=1, received=0
pcm0: timeout in reset
pcm0: hdac_command_send_internal: TIMEOUT numcmd=1, sent=1, received=0
pcm0: hdac_command_send_internal: TIMEOUT numcmd=1, sent=1, received=0

So, Chen, you could try not to mix sound with S3 suspension.

2007/1/7, Dennis Melentyev <dennis.melentyev at gmail.com>:
> Well, xUSSR are slowly coming back to life...
> Happy everything, guys'n'girls!
>
> Suspend was working good, but does the text below mean that resume is
> working also?
>
> Let's see what do I have:
>
> dennis at dennis > cat /boot/loader.conf
> # that's for ndis driver
> bcmwl5_sys_load="YES"
>
> # this for 915resolution
> #/etc/rc.local:/usr/local/bin/915resolution 34 1280 800
> linux_load="YES"
>
> # sound driver
> snd_hda_load="YES"
>
> # this for video on/off
> acpi_video_load="YES"
>
> # this is for bluetooth
> ng_ubt_load="YES"
>
> Mixer could need ajustments:
> dennis at dennis > mixer
> Mixer vol      is currently set to  75:75
> Mixer pcm      is currently set to  75:75
> Mixer speaker  is currently set to  75:75
> Mixer line     is currently set to  75:75
> Mixer rec      is currently set to   0:0
> Recording source: mic
>
> dennis at dennis > cat /dev/sndstat
> FreeBSD Audio Driver (newpcm: 64bit)
> Installed devices:
> pcm0: <Intel 82801F High Definition Audio Controller> at memory
> 0xdfebc000 irq 16 kld snd_hda [20061017_0033] (1p/1r/0v channels
> duplex default)
>
> dennis at dennis > ll /dev/pcm*
> ls: No match.
>
> But sound is working (output only, no input yet)...
>
>
> 2006/12/31, Chen Xu <xuchen66 at gmail.com>:
> > Thanks Dennis,
> >
> > as recently around Dec. 25, 2006, the suspension works
> > most of times.
> >
> > For sound, I did what the link says, but got so sound coming
> > out the speaker, the pcm0 seems fine though.
> >
> > Any more advices?
> >
> > -Chen
> >
> > On 12/24/06, Dennis Melentyev <dennis.melentyev at gmail.com> wrote:
> > > For sound, check Ariff's lowlatency binaries
> > > http://people.freebsd.org/~ariff/lowlatency/
> > >
> > > For resume - yes, it never wakes up.
> > >
> > > 2006/11/16, Chen Xu <xuchen66 at gmail.com>:
> > > > Dear list,
> > > >
> > > > I searched but could not fine enough information. Here is my problem:
> > > > zzz or acpiconf -s 3 both seems working, i.e. put the laptop into
> > > > standby mode. However, it doesn't wake up -- open the lid or press on
> > > > the power button seem to have some disk activity, but nothing is on
> > > > the display.
> > > >
> > > > Hardware: Dell 1300, everything works except sound card and resume.
> > > > FreeBSD: 6.2-prerelease
> > > >
> > > > Anyone can point me a direction what to check?
> > > >
> > > > Thanks,
> > > > -Chen
> > > > _______________________________________________
> > > > freebsd-mobile at freebsd.org mailing list
> > > > http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> > > > To unsubscribe, send any mail to "freebsd-mobile-unsubscribe at freebsd.org"
> > > >
> > >
> > >
> > > --
> > > Dennis Melentyev
> > >
> >
> >
> > --
> > Chen Xu
> > Brandeis University
> > Rosenstiel Center, MS029
> > Waltham, MA 02454
> > (Office)781-736-2469
> > (Fax)781-736-2419
> >
>
>
> --
> Dennis Melentyev
>


-- 
Dennis Melentyev