netgear wg511t pccard on Clevo m120_w

[felix.schalck]

Dana Ferguson wrote:
> Opps forgot the list...
>
> Here is how my Atheros A/B/G card is set up in rc.conf.
>
>
> # -- sysinstall generated deltas -- # Sun Sep 17 13:05:14 2006
> # Created: Sun Sep 17 13:05:14 2006
> # Enable network daemons for user convenience.
> # Please make all changes to this file, not to /etc/defaults/rc.conf.
> # This file now contains just the overrides from /etc/defaults/rc.conf.
> inetd_enable=YES
> nfs_client_enable=YES
> sshd_enable=YES
> nisdomainname="fergus"
> nis_client_enable=YES
> gdm_enable="YES"
> usbd_enable=YES
> hostname=FreeBSD.
> ifconfig_ath0="dhcp ssid Ferguson_Ranch"
> ntpd_enable=YES
> sendmail_enable=YES
> network_interfaces=ath0
>
> Dana
>
>
> On Sat, 2006-10-07 at 18:17 +0200, felix.schalck wrote:
>
>   
>> Lars Engels wrote:
>>     
>>> On Sat, Oct 07, 2006 at 06:05:41PM +0200, felix.schalck wrote:
>>>   
>>>       
>>>> Hi,
>>>>
>>>> I'm trying to get the Netgear wg511t working under 6.x.
>>>> Card works well under linux.
>>>> Dmesg shows:
>>>> --------
>>>> #dmesg | grep card
>>>> cardbus0: <CardBus bus> on cbb0
>>>> pccard0: <16-bit PCCard bus> on cbb0
>>>> ---------
>>>> rc.conf:
>>>> pccard_enable="YES"
>>>> ---------
>>>>
>>>> but when I insert the card: nothing.
>>>>
>>>> What can I do ?
>>>>
>>>> Thanks for help.
>>>>
>>>> Felix
>>>>     
>>>>         
>>> Check, if you have if_ath.ko is loaded (kldstat -v | grep ath)
>>>
>>> Lars
>>>   
>>>       
>> Yauu: that was fast ! Thanks a lot for your response.
>> Yes if_ath loaded:
>>
>> kldstat -v | grep ath
>>                 28 ath_hal
>>                 37 ath_rate
>>                 38 pci/if_ath
>>                 39 cardbus/if_ath
>>
>> What  else can i inverstigate ?
>>
>> Felix
>>     
Thanks for help, but i don't think my problem is a inet config prob.
Trying to find a solution, I enabled cardbus debug.
Here is what I get, when I insert the card:

Status is 0x30000086
Status is 0x30000820
cbb0: card inserted: event=0x00000000, state=30000820
cbb0: cbb_power: 3V
cbb0: cbb_power: 0V

Any ideas from here ?

Thanks a lot,

Felix
>> _______________________________________________
>> freebsd-mobile at freebsd.org mailing list
>> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
>> To unsubscribe, send any mail to "freebsd-mobile-unsubscribe at freebsd.org"
>>     
> _______________________________________________
> freebsd-mobile at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> To unsubscribe, send any mail to "freebsd-mobile-unsubscribe at freebsd.org"
>
>
>