NDISsulator: Setting up a 3Com pc card

[Jochen Gensch]

Tim Bishop wrote:

> Any suggestions?

No :-(

But here is my panic message if that helps someone. I had to type it 
down, so hopefully there is no mistake in there...
I got this message, when I tried to bring ndis0 up at boot time by 
rc.conf with wep enable. I haven't tried an open system, yet.

Fatal trag 12: page fault while in kernel mode
cpuid = 0; apic id =00
fault virtual address = 0x0
fault code = supervisor write, page not present
instruction pointer = 0x8:0xe1dbf8f0
frame pointer       = 0x10:0xe1dbf988
code segment        = base 0x0, limit 0xfffff, type 0x1b
                     = DPL 0, pres 1, def32 1, gra 1
processort flags    = interrupt enabled, resume, IOPL = 0
current process	    = 195 (ifconfig)
trap number         = 12
panic: page fault
cpuid = 0


Cheers, Jochen