ECS/PCChips G713 - PCI problems

[Marcos Hiroshi Umino]

On Sun, 27 Jun 2004 23:38:08 -0400
John Baldwin <jhb at FreeBSD.org> wrote:

>>   pciconf -lv returns *NO* data, no error message, nothing. It simply
>> returns to the prompt. I see no data on /dev/pci. Booting with ACPI >>orders
>> me to reboot, last message says something about ACPI not able to >>gather pci
>> device table. Booting without ACPI tells me some unknown PNP devices
>> weren't enabled.
 
> Can you write down the exact error message you get telling you to reboot?

  Yes, here it is:

Booting from FreeBSD 5.2.1-RELEASE instalation CD:

  - With ACPI enabled:
<...>
acpi0: <AMIInst SiS740XX> on motherboard
pci_open(1):	mode 1 addr port(0x0cf8) is 0xff001047
pci_open(2):	mode 2 enable port(0cf8) is 0xff
panic: AcpiOsDerivePciId unable to initialize pci bus
cpuid = 0;
Uptime: 1s
(Auto reboot request)

  Also, here is the messagem from dmesg when booting with ACPI disabled, in this situation "pciconf -lv" returns no data.

<...>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
unknown: <PNP0303> can't assign resources (port)
unknown: <PNP0510> can't assign resources (port)
unknown: <PNP0f13> can't assign resources (irq)
<...>

 I guess these are the important error messages. Maybe I can put some manual addressing on loader.conf, perhaps... But I have no idea what would be the proper entries.

 I tried installing 4.10-RELEASE, I had no success either, however, I didn't check the error messages to see if they differ.

 Any idea you have will be really welcome. Also, if you need anything else please ask.

 Thanks again,

  Marcos.