D-Link DFE-670TXD 16-bit 10/100 Ethernet NIC support (w/patch)

[David Wolfskill]

After breaking Yet Another Dongle, and (finally -- after about 6 months)
getting sufficiently tired of trying to place the pieces in Just The Right
Position so I could still use the NIC, I finally decided to replace the
most recent wired NIC I use on my laptop.

Of the available choices, one that seemed most advantageous from the
perspective of someone who's been out of work for almost 1.5 years was
the D-Link DFE-670TXD -- it's 16-bit, so I figured it ought to be able
to be used under -STABLE.

As it happens, the first time I tried it, I was running -CURRENT (with
the default NEWCARD configuration); it seemed to work OK (with one
wierd glitch I'll mention later).

But then, when I booted up -STABLE, pccardd whined that it couldn't
find an entry that matched.

Fine.  I copied /etc/defaults/pccard.conf to /etc, then copied the
stanza for the DFE-650, changed the names, killed pccardd, fired it
up again (pointing to /etc/pccard.conf this time), and it worked.

So I just got around to submitting a PR (misc/53356 --
http://www.freebsd.org/cgi/query-pr.cgi?pr=53356) to document the
patch (which I'll also append after my .sig in this message).

As I noted in the PR, I expect that this change would be a rather
low-risk one.

The wierd glitch under -CURRENT is that if the card is inserted, and
I issue a "reboot" command, the sysem starts shutting down, does
the active-buffer countdown, reorts "done", and then just sits there.

If I eject the card, the system then reports "Rebooting" and proceeds
normally.  Otherwise, it seems content to merely sit there indefinitely.

Anyway, if some committer would be kind enough to take care of this,
I'll be able to go back to just using the stock
/etc/defaults/pccard.conf in -STABLE.  :-)

Thanks,
david
-- 
David H. Wolfskill				david at catwhisker.org
Based on what I have seen to date, the use of Microsoft products is not
consistent with reliability.  I recommend FreeBSD for reliable systems.

--- pccard.conf	Sun Feb 16 06:44:54 2003
+++ ../pccard.conf	Fri Jun 13 22:23:33 2003
@@ -541,6 +541,12 @@
 	insert	/etc/pccard_ether $device start
 	remove	/etc/pccard_ether $device stop
 
+# D-Link DFE-670 Fast Ethernet Card
+card "D-Link" "DFE-670TXD"
+	config	auto "ed" ? 0x80010
+	insert	/etc/pccard_ether $device start
+	remove	/etc/pccard_ether $device stop
+
 # D-Link DME-560T LAN/FAX/MODEM Card (as Ethernet)
 card "D-Link" "DME560T"
 	config	default "ed" ?