APM problems under FreeBSD 5.1-RELEASE on IBM Thinkpad A30p

[Jesse Guardiani]

Jesse Guardiani wrote:

Hmmm... I use GMANE to read and post mail.
It appears that I can't post attachments through
the GMANE mail-to-news gateway.

So here's the dmesg in-line:

,----[ /usr/home/jesse/dmesg.boot ]
| Copyright (c) 1992-2003 The FreeBSD Project.
| Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
|       The Regents of the University of California. All rights reserved.
| FreeBSD 5.1-RELEASE #0: Tue Jun 10 17:54:58 EDT 2003
|     jesse at trevarthan.int.wingnet.net:/usr/src/sys/i386/compile/TREVARTHAN
| Preloaded elf kernel "/boot/kernel/kernel" at 0xc0700000.
| Timecounter "i8254"  frequency 1193182 Hz
| CPU: Intel(R) Pentium(R) III Mobile CPU      1200MHz (1198.99-MHz 686-class CPU)
|   Origin = "GenuineIntel"  Id = 0x6b1  Stepping = 1
|   Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
| real memory  = 402063360 (383 MB)
| avail memory = 382943232 (365 MB)
| Pentium Pro MTRR support enabled
| npx0: <math processor> on motherboard
| npx0: INT 16 interface
| pcibios: BIOS version 2.10
| Using $PIR table, 14 entries at 0xc00fdeb0
| apm0: <APM BIOS> on motherboard
| apm0: found APM BIOS v1.2, connected at v1.2
| pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
| pci0: <PCI bus> on pcib0
| agp0: <Intel 82830 host to AGP bridge> mem 0xd0000000-0xdfffffff at device 0.0 on pci0
| pcib1: <PCIBIOS PCI-PCI bridge> at device 1.0 on pci0
| pci1: <PCI bus> on pcib1
| pci1: <display, VGA> at device 0.0 (no driver attached)
| uhci0: <Intel 82801CA/CAM (ICH3) USB controller USB-A> port 0x1800-0x181f irq 9 at device 29.0 on pci0
| usb0: <Intel 82801CA/CAM (ICH3) USB controller USB-A> on uhci0
| usb0: USB revision 1.0
| uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
| uhub0: 2 ports with 2 removable, self powered
| uhci1: <Intel 82801CA/CAM (ICH3) USB controller USB-B> port 0x1820-0x183f irq 11 at device 29.1 on pci0
| usb1: <Intel 82801CA/CAM (ICH3) USB controller USB-B> on uhci1
| usb1: USB revision 1.0
| uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
| uhub1: 2 ports with 2 removable, self powered
| ums0: Logitech USB Receiver, rev 1.10/16.00, addr 2, iclass 3/1
| ums0: 7 buttons and Z dir.
| uhci2: <Intel 82801CA/CAM (ICH3) USB controller USB-C> port 0x1840-0x185f irq 9 at device 29.2 on pci0
| usb2: <Intel 82801CA/CAM (ICH3) USB controller USB-C> on uhci2
| usb2: USB revision 1.0
| uhub2: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
| uhub2: 2 ports with 2 removable, self powered
| pcib2: <PCIBIOS PCI-PCI bridge> at device 30.0 on pci0
| pci2: <PCI bus> on pcib2
| cbb0: <RF5C478 PCI-CardBus Bridge> mem 0x50000000-0x50000fff irq 9 at device 0.0 on pci2
| start (50000000) < sc->membase (c0200000)
| start (50000000) < sc->pmembase (e8000000)
| cardbus0: <CardBus bus> on cbb0
| pccard0: <16-bit PCCard bus> on cbb0
| cbb1: <RF5C478 PCI-CardBus Bridge> mem 0x50100000-0x50100fff irq 5 at device 0.1 on pci2
| start (50100000) < sc->membase (c0200000)
| start (50100000) < sc->pmembase (e8000000)
| cardbus1: <CardBus bus> on cbb1
| pccard1: <16-bit PCCard bus> on cbb1
| fwohci0: vendor=1180, dev=522
| fwohci0: <1394 Open Host Controller Interface> mem 0xc0201000-0xc02017ff irq 9 at device 0.2 on pci2
| fwohci0: OHCI version 1.0 (ROM=0)
| fwohci0: No. of Isochronous channel is 4.
| fwohci0: EUI64 00:06:1b:02:01:00:24:63
| fwohci0: Phy 1394a available S400, 2 ports.
| fwohci0: Link S400, max_rec 2048 bytes.
| firewire0: <IEEE1394(FireWire) bus> on fwohci0
| if_fwe0: <Ethernet over FireWire> on firewire0
| if_fwe0: Fake Ethernet address: 02:06:1b:00:24:63
| sbp0: <SBP2/SCSI over firewire> on firewire0
| fwohci0: Initiate bus reset
| wi0: <Intersil Prism2.5> mem 0xf0000000-0xf0000fff irq 9 at device 2.0 on pci2
| wi0: 802.11 address: 00:20:e0:8a:90:61
| wi0: using RF:PRISM2.5 MAC:ISL3874A(Mini-PCI)
| wi0: Intersil Firmware: Primary (1.1.0), Station (1.4.2)
| wi0: supported rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
| fxp0: <Intel 82801CAM (ICH3) Pro/100 VE Ethernet> port 0x8000-0x803f mem 0xc0200000-0xc0200fff irq 10 at device 8.0 on pci2
| fxp0: Ethernet address 00:d0:59:aa:70:ec
| miibus0: <MII bus> on fxp0
| inphy0: <i82562ET 10/100 media interface> on miibus0
| inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
| isab0: <PCI-ISA bridge> at device 31.0 on pci0
| isa0: <ISA bus> on isab0
| atapci0: <Intel ICH3 UDMA100 controller> port 0x1860-0x186f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device 31.1 on pci0
| ata0: at 0x1f0 irq 14 on atapci0
| ata1: at 0x170 irq 15 on atapci0
| ichsmb0: <Intel 82801CA (ICH3) SMBus controller> port 0x1880-0x189f irq 5 at device 31.3 on pci0
| smbus0: <System Management Bus> on ichsmb0
| smb0: <SMBus generic I/O> on smbus0
| pcm0: <Intel 82801CA (ICH3)> port 0x18c0-0x18ff,0x1c00-0x1cff irq 5 at device 31.5 on pci0
| pcm0: <Cirrus Logic CS4299 AC97 Codec>
| pci0: <simple comms> at device 31.6 (no driver attached)
| eisa0: <EISA bus> on motherboard
| eisa0: unknown card @H at 0000 (0x01000000) at slot 1
| orm0: <Option ROMs> at iomem 0xe0000-0xeffff,0xdc000-0xdffff,0xd1000-0xd1fff,0xd0000-0xd0fff,0xc0000-0xcffff on isa0
| pmtimer0 on isa0
| atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
| atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
| kbd0 at atkbd0
| psm0: <PS/2 Mouse> irq 12 on atkbdc0
| psm0: model Generic PS/2 mouse, device ID 0
| fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
| fdc0: FIFO enabled, 8 bytes threshold
| fd0: <1440-KB 3.5" drive> on fdc0 drive 0
| ppc0: <Parallel port> at port 0x3bc-0x3c3 irq 7 on isa0
| ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
| ppbus0: <Parallel port bus> on ppc0
| plip0: <PLIP network interface> on ppbus0
| lpt0: <Printer> on ppbus0
| lpt0: Interrupt-driven port
| ppi0: <Parallel I/O> on ppbus0
| sc0: <System console> at flags 0x100 on isa0
| sc0: VGA <16 virtual consoles, flags=0x300>
| sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
| sio0: type 16550A
| sio1 at port 0x2f8-0x2ff irq 3 on isa0
| sio1: type 16550A
| vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
| unknown: <PNP0303> can't assign resources (port)
| unknown: <PNP0c02> can't assign resources (memory)
| unknown: <PNP0680> can't assign resources (port)
| unknown: <PNP0680> can't assign resources (port)
| unknown: <IBM3780> can't assign resources (irq)
| unknown: <PNP0501> can't assign resources (port)
| unknown: <IBM0071> can't assign resources (port)
| unknown: <PNP0700> can't assign resources (port)
| unknown: <PNP0400> can't assign resources (port)
| Timecounters tick every 10.000 msec
| fwohci0: BUS reset
| fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
| firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
| firewire0: bus manager 0 (me)
| ata1-slave: timeout waiting for interrupt
| ata1-slave: ATAPI identify failed
| ad0: 45780MB <IC25T048ATDA05-0> [93015/16/63] at ata0-master UDMA100
| acd0: DVD-ROM <HL-DT-STDVD-ROM GDR8081N> at ata1-master PIO4
| Mounting root from ufs:/dev/ad0s3a
| WARNING: / was not properly dismounted
| WARNING: /tmp was not properly dismounted
| WARNING: /usr was not properly dismounted
| WARNING: /var was not properly dismounted
| /var: mount pending error: blocks 8 files 0
| /var: superblock summary recomputed`----

-- 
Jesse Guardiani, Systems Administrator
WingNET Internet Services,
P.O. Box 2605 // Cleveland, TN 37320-2605
423-559-LINK (v)  423-559-5145 (f)
http://www.wingnet.net