Toshiba Laptop Page Fault in pccard_scan_cis

[Raymond Jimenez]

	I have an old Toshiba laptop (225 CDS) that's been working fine with 
PCMCIA cards until I upgraded to -CURRENT. In 4.8-RELEASE, FreeBSD 
recognized the slots fine, and detected the cards as well. However, in 
-CURRENT, it doesn't detect the cards or the slots. In 4.8, the cards 
were in the mode "PCIC-Compatible" in the BIOS. This mode didn't work 
with -CURRENT, and so I turned it to "CardBus/16-Bit". -CURRENT 
recognizes the slots, but whenever a card is present on bootup or when 
one is inserted (after loading the modules) I get the following page fault:

shirayuki# kldload cardbus
shirayuki# kldload pccard
shirayuki# kldload cbb
cbb0: <ToPIC95B PCI-CardBus Bridge> irq 11 at device 2.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb1: <ToPIC95B PCI-CardBus Bridge> irq 11 at device 2.1 on pci0
cardbus1: <CardBus bus> on cbb1
pccard1: <16-bit PCCard bus> on cbb1


Fatal trap 12: page fault while in kernel mode
fault virtual address   = 0xc64cb000
fault code              = supervisor read, page not present
instruction pointer     = 0x8:0xc15f36b5
stack pointer           = 0x10:0xc61d694c
frame pointer           = 0x10:0xc61d6b64
code segment            = base 0x0, limit 0xfffff, type 0x1b
                         = DPL 0, pres 1, def32 1, gran 1
processor eflags        = interrupt enabled, resume, IOPL = 0
current process         = 502 (cbb0)
kernel: type 12 trap, code=0
Stopped at      pccard_scan_cis+0x175:  movzbl  0(%eax,%edx,1),%eax
db>


output of dmesg:

Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
         The Regents of the University of California. All rights reserved.
FreeBSD 5.1-CURRENT #0: Sun Jul 20 20:45:11 PDT 2003
     raymond at shirayuki.wsyntax.com:/usr/obj/usr/src/sys/SHIRAYUKI
Preloaded elf kernel "/boot/kernel/kernel" at 0xc05c2000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc05c21cc.
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 132632637 Hz
CPU: Pentium/P54C (132.63-MHz 586-class CPU)
   Origin = "GenuineIntel"  Id = 0x52c  Stepping = 12
   Features=0x1bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8>
real memory  = 67239936 (64 MB)
avail memory = 59207680 (56 MB)
Intel Pentium detected, installing workaround for F00F bug
VESA: v2.0, 2048k memory, flags:0x0, mode table:0xc051d660 (1000040)
VESA: CHIPS 6x554 Super VGA
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcibios: BIOS version 2.10
Using $PIR table, 3 entries at 0xc00f97e0
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
pci_cfgintr: 0:2 INTA BIOS irq 11
pci_cfgintr: 0:2 INTB BIOS irq 11
pci_cfgintr: 0:11 INTA BIOS irq 11
pci0: <bridge, PCI-CardBus> at device 2.0 (no driver attached)
pci0: <bridge, PCI-CardBus> at device 2.1 (no driver attached)
pci0: <display, VGA> at device 4.0 (no driver attached)
ohci0: <NEC uPD 9210 USB controller> mem 0xfdfff000-0xfdffffff irq 11 at 
device 11.0 on pci0
usb0: OHCI version 1.0
usb0: <NEC uPD 9210 USB controller> on ohci0
usb0: USB revision 1.0
uhub0: NEC OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
isa0: <ISA bus> on motherboard
pmtimer0 on isa0
ata0 at port 0x3f6,0x1f0-0x1f7 irq 14 on isa0
ata1 at port 0x376,0x170-0x177 irq 15 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model GlidePoint, device ID 0
fdc0: <NEC 765 or clone> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/16 bytes threshold
ppbus0: <Parallel port bus> on ppc0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x100>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A, console
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
pca0: <AT-style speaker sound> at port 0x61 on isa0
unknown: <PNP0303> can't assign resources (port)
unknown: <TOS7400> can't assign resources (irq)
unknown: <PNP0700> can't assign resources (port)
unknown: <PNP0600> can't assign resources (port)
unknown: <PNP0600> can't assign resources (port)
unknown: <PNP0501> can't assign resources (port)
unknown: <PNP0401> can't assign resources (port)
pcm0: <Yamaha OPL-SAx> at port 
0x370-0x371,0x330-0x331,0x388-0x38b,0x530-0x537,0x220-0x22f irq 5 drq 
0,1 on isa0
Timecounters tick every 10.000 msec
IPsec: Initialized Security Association Processing.
IP Filter: v3.4.31 initialized.  Default = block all, Logging = enabled
ad0: 7815MB <IBM-DYLA-28100> [15880/16/63] at ata0-master PIO4
acd0: CDROM <TOSHIBA CD-ROM XM-1602B> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s1a

output of uname -a:
FreeBSD shirayuki.wsyntax.com 5.1-CURRENT FreeBSD 5.1-CURRENT #0: Sun 
Jul 20 20:45:11 PDT 2003 
raymond at shirayuki.wsyntax.com:/usr/obj/usr/src/sys/SHIRAYUKI  i386

I've looked on Google and found a few threads detailing this discussion, 
but the thread ended with "Oh, with some card/bridge combinations, we 
don't map the CIS address space correctly." The man pages don't say 
anything about this.

Any help would be greatly appreciated.
-Raymond

-- 
Raymond Jimenez ("Cyanoacry") <raymond at naru.wsyntax.com>
http://chikage.wsyntax.com <> cyanoacry at rakka.irc.wsyntax.com