pccard & wi

[Konstantin Nikonenko]

Hello freebsd-mobile,

  Have:
  Standart PC configuration on Intel motherboard, PCI-PCMCIA bridge
  with Orinoco wavelan.
uname -a
FreeBSD plant.d-sto.com 5.1-CURRENT FreeBSD 5.1-CURRENT #19: Wed Jul  9 13:39:12 EEST 2003
  kernel maked from file, where OLDSTYLE configure
# PCCARD (PCMCIA) support
# Pcmcia and cardbus bridge support
nodevice                cbb                     # cardbus (yenta) bridge
device          pcic                    # ExCA ISA and PCI bridges
device          card 2
nodevice                pccard                  # PC Card (16-bit) bus
nodevice                cardbus                 # CardBus (32-bit) bus
   from dmesg i can view next:
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pcib0: slot 2 INTA is routed to irq 11
pcib0: slot 31 INTD is routed to irq 3
pcib0: slot 31 INTB is routed to irq 10
pcib0: slot 31 INTC is routed to irq 9
...
pcib1: _PRS resource entry has unsupported type 2
pcic0: <Ricoh RL5C475 PCI-CardBus Bridge> at device 10.0 on pci1
pcic0: PCI Memory allocated: 0xff800000
pcib1: _PRS resource entry has unsupported type 2
pcic0: No PCI interrupt routed, trying ISA.
pcic0: Polling mode
...
pccard: card inserted, slot 0
wi0 at port 0x240-0x27f irq 10 slot 0 on pccard0
wi0: 802.11 address: 00:60:1d:f6:7f:51
wi0: using Lucent Technologies, WaveLAN/IEEE
wi0: Lucent Firmware: Station (6.6.1)
wi0: supported rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
   card is configured via ifconfig in /etc/rc.conf
pccard_enable="YES"
pccard_ifconfig="YES"
removable_interfaces="wi0"
ifconfig_wi0="inet A.B.C.D netmask 255.255.255.240 media DS/11Mbps
mediaopt adhoc stationname XXX ssid YYYY channel 10"
   ifconfig wi0 say next
wi0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet A.B.C.D netmask 0xfffffff0 broadcast a.b.c.d
        ether 00:02:2d:28:0b:79
        media: IEEE 802.11 Wireless Ethernet DS/11Mbps <adhoc>
        status: no carrier
        ssid my_name
        stationname DSTO
        channel 10 authmode OPEN powersavemode OFF powersavesleep 100
        wepmode OFF weptxkey 1
adhoc mode i put from you recommendation from this maillist. Another
side is in BSS mode.

Interface doesn't work. :( ping say, that host is down. In FreeBSD 4.X
all working beautiful ;) without any errors.

mb i must configure in kernel in another way? But in this case
interface is not founding.

-- 
Cheers,
 Konstantin Nikonenko        http://www.kot.dp.ua/