Trap when setting up ath0
Florian Kruegl
fk at bsdler.de
Sat May 1 16:00:25 UTC 2010
Hi
On Sat, 2010-05-01 at 11:09 +0100, Rui Paulo wrote:
> On 1 May 2010, at 09:38, Florian Kruegl wrote:
>
> > Hi,
> >
> > I get a trap when setting up wlan interface on RS pro.
>
> Maybe this is because some structure is misaligned. Can you enable AH_DEBUG and ATH_DEBUG and edit {if_ath.c,ah_osdep.c} so that ath_debug=0xffffffff and ath_hal_debug=0xffffffff ?
>
--------------< bootup >--------------
ath0: <Atheros 9280> irq 1 at device 18.0 on pci0
ath0: [ITHREAD]
ath_getchannels: eeprom rd 32924 cc 156 (mapped rd 32924 cc 156)
location I ecm
ath_descdma_setup: rx DMA: 40 buffers 1 desc/buf
ath_descdma_setup: rx DMA map: 0xa0923000 (3840) -> 0x923000 (3840)
ath_descdma_setup: tx DMA: 200 buffers 10 desc/buf
ath_descdma_setup: tx DMA map: 0xa0980000 (192000) -> 0x980000 (192000)
ath_descdma_setup: beacon DMA: 4 buffers 1 desc/buf
ath_descdma_setup: beacon DMA map: 0xa0970000 (384) -> 0x970000 (384)
ath0: AR9280 mac 128.2 RF5133 phy 13.0
--------------< bootup >--------------
--------------< setup >--------------
xerxes# ifconfig ath0 up
ath_init: if_flags 0x8803
ath_stop_locked: invalid 0 if_flags 0x8803
Trap cause = 7 (bus error (load or store) - kernel mode)
[ thread pid 1809 tid 100067 ]
Stopped at platform_start+0x1b10: srl v0,a1,8
--------------< setup >--------------
Regards
Flo
More information about the freebsd-mips
mailing list