Bluetooth USB Host Controller Atheros Communications

[Alberto Mijares]

>> Since this is the first instruction in section 31.5.1 from the
>> handbook, this was the first command I typed. The module is already
>> loaded.
>>
>> However
>>
>> # ls /dev/ubt*
>> ls: No match.
>>
>> Should the device be recognized? What else should I try?
>>
>
> usbconfig show_ifdrv
>

% usbconfig show_ifdrv
ugen0.1: <XHCI root HUB 0x8086> at usbus0, cfg=0 md=HOST spd=SUPER
(5.0Gbps) pwr=SAVE (0mA)
ugen0.1.0: uhub0: <0x8086 XHCI root HUB, class 9/0, rev 3.00/1.00, addr 1>
ugen1.1: <EHCI root HUB Intel> at usbus1, cfg=0 md=HOST spd=HIGH
(480Mbps) pwr=SAVE (0mA)
ugen1.1.0: uhub1: <Intel EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1>
ugen2.1: <EHCI root HUB Intel> at usbus2, cfg=0 md=HOST spd=HIGH
(480Mbps) pwr=SAVE (0mA)
ugen2.1.0: uhub2: <Intel EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1>
ugen1.2: <product 0x0024 vendor 0x8087> at usbus1, cfg=0 md=HOST
spd=HIGH (480Mbps) pwr=SAVE (0mA)
ugen1.2.0: uhub3: <vendor 0x8087 product 0x0024, class 9/0, rev
2.00/0.00, addr 2>
ugen2.2: <product 0x0024 vendor 0x8087> at usbus2, cfg=0 md=HOST
spd=HIGH (480Mbps) pwr=SAVE (0mA)
ugen2.2.0: uhub4: <vendor 0x8087 product 0x0024, class 9/0, rev
2.00/0.00, addr 2>
ugen1.3: <USB2.0-CRW Generic> at usbus1, cfg=0 md=HOST spd=HIGH
(480Mbps) pwr=ON (500mA)
ugen1.4: <Bluetooth USB Host Controller Atheros Communications> at
usbus1, cfg=0 md=HOST spd=FULL (12Mbps) pwr=O